An investigation of the influence of alternative process plans on equipment control
作者： Joao C.E. Ferreira , Richard A. Wysk
DOI: 10.1016/S0278-6125(01)80011-X
关键词: Machining 、 Alternative process 、 Flexible manufacturing system 、 Machine control 、 Manufacturing 、 Production schedule 、 Engineering 、 Manufacturing engineering 、 Master production schedule 、 Machine tool
摘要: Most manufacturing industries today use fixed (linear) process plans, which do not convey adequate requirements for both control and planning. The inclusion of pre-planned alternatives in the plans should enable faster more efficient decisions, manned automated environs. This paper investigates plan at machine (equipment) level. A model is proposed to represent these efficiencies associated with their execution are investigated. Machine-specific studied no or tool failure. An experiment performed analyze performance such a schema, where variables considered parts be manufactured, master production schedule that changes over time, dynamic set cutting tools needed parts. work consists comparing whether it better to: (1) static optimal local plan, (2) current tooling new batch parts, (3) partially up some alternative yet place order accomplish manufacture part.
elsevier.com
sci-hub.se 参考文章(8)
P.-H. Koo, Real-time operation and tool selection in single stage multimachine systems International Journal of Production Research. ,vol. 37, pp. 1023- 1039 ,(1999) , 10.1080/002075499191382
S. LEE, R. A. WYSK, J. S. SMITH, Process planning interface for a shop floor control architecture for computer-integrated manufacturing International Journal of Production Research. ,vol. 33, pp. 2415- 2435 ,(1995) , 10.1080/00207549508904824
P. Xirouchakis, D. Kiritsis, J.-G. Persson, A Petrinet Technique for Process Planning Cost Estimation CIRP Annals. ,vol. 47, pp. 427- 430 ,(1998) , 10.1016/S0007-8506(07)62867-4
J.I. Llorente, M.I. Sarachaga, A. Burgos, J. Viñolas, R. Bueno, Ramon Bueno, Reuse of Control Software for Manufacturing Systems CIRP Annals. ,vol. 46, pp. 403- 406 ,(1997) , 10.1016/S0007-8506(07)60852-X
BRYAN A. CATRON, STEVEN R. RAY, ALPS: A Language for Process Specification International Journal of Computer Integrated Manufacturing. ,vol. 4, pp. 105- 113 ,(1991) , 10.1080/09511929108944485
W. E. WILHELM, HYUN-MYUNG SHIN, Effectiveness of alternate operations in a flexible manufacturing system International Journal of Production Research. ,vol. 23, pp. 65- 79 ,(1985) , 10.1080/00207548508904691
H. Cho, A. Derebail, T. Hale, R. A. Wysk, A Formal Approach to Integrating Computer-Aided Process Planning and Shop Floor Control Journal of Engineering for Industry. ,vol. 116, pp. 108- 116 ,(1994) , 10.1115/1.2901800
J.P. Kruth, J. Detand, A CAPP System for Nonlinear Process Plans CIRP Annals. ,vol. 41, pp. 489- 492 ,(1992) , 10.1016/S0007-8506(07)61251-7