Electrification of fine particles by impact on a polymer film target

作者: Shuji Matsusaka , Tomonori Nishida , Yoshiaki Gotoh , Hiroaki Masuda

DOI: 10.1163/156855203762469939

关键词: ElectrometerElectric currentDielectric strengthCurrent (fluid)Range (particle radiation)Materials scienceComposite materialParticlePolymerAirflow

摘要: Abstract Impact charging between fine particles and polymer film has been investigated both theoretically experimentally. A powder, fly-ash of 12 μ mass median diameter, was dispersed acceleratedin air flow, then the were impacted on a target whose frontal surface covered with rear side metal plate. The films used in range 25-250 thick. plate grounded electric currents caused by impact measured an electrometer. Two types detected, i.e. induction current conduction current. due to charge accumulating film, whereas dielectric breakdown arising from particle impact. Using small artificial holes, detected. This fact shows that insulating material can be utilized as effective chargingwall long accumulation is well suppressed.

参考文章(10)
W. KLEBER, B. MAKIN, TRIBOELECTRIC POWDER COATING: A PRACTICAL APPROACH FOR INDUSTRIAL USE Particulate Science and Technology. ,vol. 16, pp. 43- 53 ,(1998) , 10.1080/02726359808906783
R. Gupta, D. Gidaspow, D.T. Wasan, Electrostatic separation of powder mixtures based on the work functions of its constituents Powder Technology. ,vol. 75, pp. 79- 87 ,(1993) , 10.1016/0032-5910(93)80027-8
Hiroaki Masuda, Shuji Matsusaka, Shinji Nagatani, Measurements of powder flow rate in gas-solids pipe flow based on the static electrification of particles Advanced Powder Technology. ,vol. 5, pp. 241- 254 ,(1994) , 10.1163/156855294X00320
Hiroaki Masuda, Takahiro Komatsu, Koichi Iinoya, The static electrification of particles in gas-solids pipe flow Aiche Journal. ,vol. 22, pp. 558- 564 ,(1976) , 10.1002/AIC.690220320
B. N. Cole, M. R. Baum, F. R. Mobbs, An Investigation of Electrostatic Charging Effects in High-Speed Gas-Solids Pipe Flows Proceedings of the Institution of Mechanical Engineers, Conference Proceedings. ,vol. 184, pp. 77- 83 ,(1969) , 10.1243/PIME_CONF_1969_184_082_02
Indra Adhiwidjaja, Shuji Matsusaka, Hiroaki Masuda, Mechanism of Formation of Particle Deposition Layers by an Aerosol Flow. Kagaku Kogaku Ronbunshu. ,vol. 22, pp. 127- 133 ,(1996) , 10.1252/KAKORONBUNSHU.22.127
Hiroaki MASUDA, Shuji MATSUSAKA, Hiroaki SHIMOMURA, Measurement of the Mass Flow Rate of a Polymer Powder Based on the Static Electrification of Particles. Journal of The Society of Powder Technology, Japan. ,vol. 34, pp. 919- 923 ,(1997) , 10.4164/SPTJ.34.919
Hiroaki Masuda, Shuji Matsusaka, Hiroaki Shimomura, Measurement of mass flow rate of polymer powder based on static electrification of particles Advanced Powder Technology. ,vol. 9, pp. 169- 179 ,(1998) , 10.1016/S0921-8831(08)60585-3