A proposed strategy for power optimization of a wind energy conversion system connected to the grid

作者: S. Taraft , D. Rekioua , D. Aouzellag , S. Bacha

DOI: 10.1016/J.ENCONMAN.2015.05.047

关键词: Control theoryRotor (electric)Power controlPower factorPower optimizationMaximum power point trackingPower ratingPower optimizerEngineeringWind power

摘要: Abstract Many strategies have been developed in last decade to optimize power extracted from wind energy conversion system where many of them can produce only 30% more than the rated power. With considered strategy, generated reach twice its nominal value using a fast and reliable fully rugged electrical control. Indeed, by employing suitable control technique produced super-synchronous mode is derived both stator rotor. Also, rotor provided this case grows up 100% comparing However, solution permits maintain operation stable area. The consists double fed induction generator whose connected directly grid supplied matrix converter. In paper, sliding approach achieve active reactive used. This latter combined with de Perturbation Observation Maximum Power Point Tracking used second zone. obtained simulations results are assessed carried out Matlab/Simulink package show performance effectiveness proposed

参考文章(36)
Djamila Rekioua, Wind Energy Conversion and Power Electronics Modeling Springer, London. pp. 51- 76 ,(2014) , 10.1007/978-1-4471-6425-8_2
A. Massoum, A. Mezouar, Kh. Belgacem, Sliding Mode Control of a Doubly-fed Induction Generator for Wind Energy Conversion International journal of energy engineering. ,vol. 3, pp. 30- 36 ,(2013)
Y. Soufi, EL-Madjid Berkouk, Seifeddine Abdelkader Belfedhal, Y. Meslem, Modeling and Control of Wind Power Conversion System With a Flywheel Energy Storage System and Compensation of Reactive Power International Journal of Renewable Energy Research. ,vol. 2, pp. 528- 534 ,(2012) , 10.20508/IJRER.37438
L. Zhang, C. Watthanasarn, W. Shepherd, Application of a matrix converter for the power control of a variable-speed wind-turbine driving a doubly-fed induction generator international conference on industrial electronics control and instrumentation. ,vol. 2, pp. 906- 911 ,(1997) , 10.1109/IECON.1997.672110
EL madjid Berkouk, Seifeddine Belfedhal, Modeling and Control of Wind Power Conversion System With a Flywheel Energy Storage System International Journal of Renewable Energy Research. ,vol. 1, pp. 152- 161 ,(2011)
Sabrina Abdeddaim, Achour Betka, Said Drid, Mohamed Becherif, Implementation of MRAC controller of a DFIG based variable speed grid connected wind turbine Energy Conversion and Management. ,vol. 79, pp. 281- 288 ,(2014) , 10.1016/J.ENCONMAN.2013.12.003
B. Boukhezzar, H. Siguerdidjane, Nonlinear control with wind estimation of a DFIG variable speed wind turbine for power capture optimization Energy Conversion and Management. ,vol. 50, pp. 885- 892 ,(2009) , 10.1016/J.ENCONMAN.2009.01.011
N Madani, MF Benkhoris, S Siala, MO Mahmoudi, Sliding mode control of an asynchronous motor drive 1998 Seventh International Conference on Power Electronics and Variable Speed Drives (IEE Conf. Publ. No. 456). pp. 341- 346 ,(1998) , 10.1049/CP:19980548
Elmano Margato, José Faria, M.J. Resende, João Palma, A new control strategy with saturation effect compensation for an autonomous induction generator driven by wide speed range turbines Energy Conversion and Management. ,vol. 52, pp. 2142- 2152 ,(2011) , 10.1016/J.ENCONMAN.2010.12.012