Optimization and correction of the tool path of the five-axis milling machine: Part 2: Rotations and setup
作者： Stanislav Makhanov
DOI: 10.1016/J.MATCOM.2006.12.001
关键词: Algorithm 、 Tool path 、 Computer science 、 Set (abstract data type)
摘要: Abstract We present two new algorithms (which supplement Algorithms 1, 2 and 3 presented in part 1) to optimize the tool path of five-axis numerically controlled milling machine. Algorithm 4 optimizes a set feasible rotations. 5 presents least-square optimization with regard setup machine
acm.org
elsevier.com
sci-hub.se 参考文章(9)
Mark Allen Weiss, Data Structures and Algorithm Analysis ,(1991)
E.L.J. Bohez, Five-axis milling machine tool kinematic chain design and analysis International Journal of Machine Tools & Manufacture. ,vol. 42, pp. 505- 520 ,(2002) , 10.1016/S0890-6955(01)00134-1
Y. Sijie, Z. Yunfei, P. Fangyu, L. Xide, Research on the localisation of the workpieces with large sculptured surfaces in NC machining The International Journal of Advanced Manufacturing Technology. ,vol. 23, pp. 429- 435 ,(2004) , 10.1007/S00170-003-1897-2
O.Remus Tutunea-Fatan, Hsi-Yung Feng, Configuration analysis of five-axis machine tools using a generic kinematic model International Journal of Machine Tools & Manufacture. ,vol. 44, pp. 1235- 1243 ,(2004) , 10.1016/J.IJMACHTOOLS.2004.03.009
Y.H. Jung, D.W. Lee, J.S. Kim, H.S. Mok, NC post-processor for 5-axis milling machine of table-rotating/tilting type Journal of Materials Processing Technology. ,vol. 130, pp. 641- 646 ,(2002) , 10.1016/S0924-0136(02)00725-2
Stanislav Makhanov, Optimization and correction of the tool path of the five-axis milling machine Mathematics and Computers in Simulation. ,vol. 75, pp. 210- 230 ,(2007) , 10.1016/J.MATCOM.2006.12.009
A. Affouard, E. Duc, C. Lartigue, J.-M. Langeron, P. Bourdet, Avoiding 5-axis singularities using tool path deformation International Journal of Machine Tools & Manufacture. ,vol. 44, pp. 415- 425 ,(2004) , 10.1016/J.IJMACHTOOLS.2003.10.008
M. Munlin, S.S. Makhanov, E.L.J. Bohez, Optimization of rotations of a five-axis milling machine near stationary points Computer-aided Design. ,vol. 36, pp. 1117- 1128 ,(2004) , 10.1016/S0010-4485(03)00164-7
Andrew Warkentin, Sanjeev Bedi, Fathy Ismail, Paul Hoskins, Computer-aided 5-axis machining Systems techniques and computational methods. pp. 3001- 3034 ,(2001)