Method of making a trimmed, laminated trim component
作者： Preisler Darius J , Mitchell Steven A , Heikkila Christopher A
DOI:
关键词: Pressing 、 Composite material 、 Materials science 、 Component (UML) 、 Trim 、 Layer (electronics) 、 Composite number 、 Cushioning
摘要: A method of making a trimmed, laminated trim component is provided. heated plastic composite sheet pressed against to bond cushioning layer the sheet. The step pressing compresses portion spaced inwardly from an outer periphery locally compact and thin at form compressed layer. Unwanted portions are trimmed.
lens.org 参考文章(194)
Peter Sotiropoulos, Vehicle lubrication system ,(1979)
Rainer F. Gardill, Molded panel having a decorative facing and made from a blend of natural and plastic fibers ,(1994)
Lloyd R. Hilligoss, Method and system for producing a 3-D deep-drawn article using a thermoplastic sandwich material ,(2000)
Hisakazu Yasumuro, Ken Takenouchi, Nobuyuki Kato, Process for producing deep-drawn plastic container ,(1991)
Barry M. Fell, Process for the preparation of thermoplastic sandwich structures ,(1993)
William S. Scott, Foldable boat with light weight hull construction system ,(2001)
Thierry Renault, Combination bumper skin and under-engine fairing for a vehicle ,(2000)
Glenn Snyder, Keith Boyle, Willard Crotty, Sandwich panel and method of manufacturing same ,(2005)
Lyle H. Shuert, Laminate structural plastic material ,(1990)
Katsuhiko Umeda, Continuous honeycomb panel molding method ,(1989)