Stress-induced martensite in single crystals of an Fe-23Ni-5Cr alloy
作者： Masaharu Kato , T. Mori
DOI: 10.1016/0001-6160(76)90052-3
关键词: Martensite 、 Thermodynamics 、 Shear (geology) 、 Materials science 、 Stress induced martensite 、 Crystallography 、 Slip (materials science) 、 Alloy
摘要: Abstract Asymmetrical uniaxial stress was applied to single crystals of an Fe-23%Ni-5%Cr alloy induce martensitic transformations. Slip and transformations occurred concurrently during the deformation normal temperature dependence yield observed. Stress-induced martensite in this needle-like surface martensite. Determination varients performed using X-ray Weissenberg technique. Distribution variants very sensitive sense results were well explained by postulating {111}f〈211〉f shear systems initial stage transformation. Phenomenological calculation showed less rational correlation observed stress-induced variants. The stronger tendency towards formation tension as compared compression also above postulate.
elsevier.com
sci-hub.se 参考文章(23)
N.D.H Ross, A.G Crocker, A generalized theory of martensite crystallography and its application to transformations in steels Acta Metallurgica. ,vol. 18, pp. 405- 418 ,(1970) , 10.1016/0001-6160(70)90126-4
G.H Olsen, W.A Jesser, The effect of applied stress on the f.c.c.-b.c.c. transformation in thin iron films Acta Metallurgica. ,vol. 19, pp. 1299- 1302 ,(1971) , 10.1016/0001-6160(71)90065-4
D.P Dunne, G.M Wayman, An assessment of the double shear theory as applied to ferrous martensitic transformations Acta Metallurgica. ,vol. 19, pp. 425- 438 ,(1971) , 10.1016/0001-6160(71)90166-0
A.J Bogers, W.G Burgers, Partial dislocations on the {110} planes in the B.C.C. lattice and the transition of the F.C.C. into the B.C.C. lattice Acta Metallurgica. ,vol. 12, pp. 255- 261 ,(1964) , 10.1016/0001-6160(64)90194-4
P.M. Kelly, The martensite transformation in steels with low stacking fault energy Acta Metallurgica. ,vol. 13, pp. 635- 646 ,(1965) , 10.1016/0001-6160(65)90126-4
Yakichi Higo, Francis Lecroisey, T Mori, Relation between applied stress and orientation relationship of α′ martensite in stainless steel single crystals Acta Metallurgica. ,vol. 22, pp. 313- 323 ,(1973) , 10.1016/0001-6160(74)90170-9
J.R Keiser, M Wuttig, A magnetic aftereffect in dilute h.c.p. Co-C alloys Acta Metallurgica. ,vol. 19, pp. 445- 449 ,(1971) , 10.1016/0001-6160(71)90168-4
M. F. Ashby, The deformation of plastically non-homogeneous materials Philosophical Magazine. ,vol. 21, pp. 399- 424 ,(1970) , 10.1080/14786437008238426
J.S Bowles, J.K Mackenzie, The crystallography of martensite transformations I Acta Metallurgica. ,vol. 2, pp. 129- 137 ,(1954) , 10.1016/0001-6160(54)90102-9
J.A Klostermann, W.G Burgers, Surface martensite in iron-nickel Acta Metallurgica. ,vol. 12, pp. 355- 360 ,(1964) , 10.1016/0001-6160(64)90004-5