Measuring and regulating solid charge for jet mill or impact pulverizer
作者： Mathias Dr Benz , Claus Dr Riehle , Benno Dipl Ing Ulfik , Udo Dr Kraeuter
DOI:
关键词: Charge (physics) 、 Electric signal 、 Pulverizer 、 Control theory 、 Mechanics 、 Jet mill 、 Impeller 、 Signal 、 Solid matter 、 Engineering 、 Rotor (electric)
摘要: The method involves measuring continuously the instantaneous rpm of impeller grader or rotor impact pulverizer connected with jet mill in form an signal fluctuating over time. strength fluctuations is evaluated as a measurement value for required feeding solid matter. electric derived from this used to regulate feed material.
lens.org 参考文章(10)
Birks Eric, Ball mill control device. ,(1984)
Getzmann Hermann, VERFAHREN UND VORRICHTUNG ZUR REGELUNG DER DREHZAHL BEI RUEHRWERKSKUGELMUEHLEN. ,(1991)
Aertker Paul, Method and device for protecting a percussion-hammer mill against overload ,(1988)
Yukio Kawasaki Tamura, Katsuhiro Kawasaki Ikegami, Toru Kawasaki Nakayama, Satoru Kawasaki Koyanagi, Fahrbarer Brecher und Verfahren zur Brecherregelung ,(1996)
Peter Thuerauf, Wolf-Diethard Dipl I Gruenberg, Klaus Dipl Phys Dietrich, Cylindrical pulveriser load regulation system - uses measured oscillation of pulveriser wall to determine contents grade ,(1980)
Gorobets Vladimir, METHOD OF AUTOMATIC REGULATING OF THE PROCESS OF GAS-SET DISINTEGRATION ,(1979)
Reginald Moon George Natal, Thomas Sutton Dennis, Verfahren und Vorrichtung zur Betriebsueberwachung von Muehlen ,(1971)
Kubantsev Viktor, METHOD OF AUTOMATIC CONTROL OF GRINDING PROCESS IN GAS-JET MILL ,(1980)