Increasing the energy and exergy efficiencies of a collector using porous and recycling system
作者： Akbar Arabhosseini , Hadi Samimi-Akhijahani , Mehrnosh Motahayyer
DOI: 10.1016/J.RENENE.2018.07.132
关键词: Exergy 、 Porosity 、 Environmental science 、 Thermal energy 、 Solar dryer 、 Mass flow rate 、 Environmental engineering 、 Thermal efficiency 、 Thermal 、 Airflow
摘要: Abstract Performance of a collector in solar dryer, equipped with porous and recycling system was investigated at three airflow rates (0.009, 0.018 0.036 kg/s). The CFD model applied for developing the thermal response simulation outlet air temperature, energy exergy parameters. predicted experimental data were analyzed. results illustrated quit good correlation between by data. maximum efficiencies 63.4% 22.3%, respectively, mass flow rate 0.009 kg/s. In general, not only improved efficiency but also accelerated drying time. about 19.1% 19.5%, respectively higher than without them. total (21.24 MJ) produced No adverse effect found on quality dried products employing dryer.
sci-hub.se 参考文章(82)
M. Aghbashlo, M.H. Kianmehr, A. Arabhosseini, T. Nazghelichi, Modelling the carrot thin-layer drying in a semi-industrial continuous band dryer. Czech Journal of Food Sciences. ,vol. 29, pp. 528- 538 ,(2018) , 10.17221/158/2010-CJFS
N. Yagnesh Sharma, K. Vasudeva Karanth, M. S. Manjunath, Numerical Simulation of a Solar Flat Plate Collector using Discrete Transfer Radiation Model (DTRM) - A CFD Approach world congress on engineering. pp. 2355- 2360 ,(2011)
N. Yagnesh Sharma, K. Vasudeva Karanth, M S Manjunath, A Comparative CFD Study on Solar Dimple Plate Collector with Flat Plate Collector to Augment the Thermal Performance World Academy of Science, Engineering and Technology, International Journal of Mechanical, Aerospace, Industrial, Mechatronic and Manufacturing Engineering. ,vol. 6, pp. 2246- 2252 ,(2012)
B. Ghobadian, M. H. Khoshtaghaza, S. Minaei, H. Mortezapour, Drying Kinetics and Quality Characteristics of Saffron Dried with a Heat Pump Assisted Hybrid Photovoltaic-thermal Solar Dryer Journal of Agricultural Science and Technology. ,vol. 16, pp. 33- 45 ,(2014)
Fahad A. Al-Sulaiman, Exergy analysis of parabolic trough solar collectors integrated with combined steam and organic Rankine cycles Energy Conversion and Management. ,vol. 77, pp. 441- 449 ,(2014) , 10.1016/J.ENCONMAN.2013.10.013
Arif Hepbasli, Exergetic modeling and assessment of solar assisted domestic hot water tank integrated ground-source heat pump systems for residences Energy and Buildings. ,vol. 39, pp. 1211- 1217 ,(2007) , 10.1016/J.ENBUILD.2007.01.007
T. Bartzanas, T. Boulard, C. Kittas, Numerical simulation of the airflow and temperature distribution in a tunnel greenhouse equipped with insect-proof screen in the openings Computers and Electronics in Agriculture. ,vol. 34, pp. 207- 221 ,(2002) , 10.1016/S0168-1699(01)00188-0
P.-S Mirade, Prediction of the air velocity field in modern meat dryers using unsteady computational fluid dynamics (CFD) models Journal of Food Engineering. ,vol. 60, pp. 41- 48 ,(2003) , 10.1016/S0260-8774(03)00009-8
S. Farahat, F. Sarhaddi, H. Ajam, Exergetic optimization of flat plate solar collectors Renewable Energy. ,vol. 34, pp. 1169- 1174 ,(2009) , 10.1016/J.RENENE.2008.06.014
S.E. Cunningham, W.A.M. Mcminn, T.R.A. Magee, P.S. Richardson, Experimental study of rehydration kinetics of potato cylinders Food and Bioproducts Processing. ,vol. 86, pp. 15- 24 ,(2008) , 10.1016/J.FBP.2007.10.008