Investigation of mechanical and machinability properties of SiC particle reinforced Al-MMC
作者： Tamer Ozben , Erol Kilickap , Orhan Çakır
DOI: 10.1016/J.JMATPROTEC.2007.06.082
关键词: Silicon carbide 、 Composite material 、 Tool wear 、 Machinability 、 Machining 、 Surface roughness 、 Metal matrix composite 、 Aluminium 、 Materials science 、 Ultimate tensile strength
摘要: The paper presents the results of experimental investigation on mechanical and machinability properties of silicon carbide particle (SiC-p) reinforced aluminium metal matrix composite. …
elsevier.com
sci-hub.se 参考文章(15)
Joël Rech, Hédi Hamdi, Stéphane Valette, Workpiece Surface Integrity Springer, London. pp. 59- 96 ,(2008) , 10.1007/978-1-84800-213-5_3
Mariam S. El-Gallab, Mateusz P. Sklad, Machining of aluminum/silicon carbide particulate metal matrix composites: Part IV. Residual stresses in the machined workpiece Journal of Materials Processing Technology. ,vol. 152, pp. 23- 34 ,(2004) , 10.1016/J.JMATPROTEC.2004.01.061
M. El-Gallab, M. Sklad, Machining of Al/SiC particulate metal matrix composites: Part II: Workpiece surface integrity Journal of Materials Processing Technology. ,vol. 83, pp. 277- 285 ,(1998) , 10.1016/S0924-0136(98)00072-7
Rees D Rawlings, Frank L Matthews, Composite materials : engineering and science Published in <b>1994</b> in London by Chapman and Hall. ,(1994)
J. D. Embury, Plastic flow in dispersion hardened materials Metallurgical Transactions A. ,vol. 16, pp. 2191- 2200 ,(1985) , 10.1007/BF02670418
J. U. Ejiofor, R. G. Reddy, Developments in the processing and properties of particulate Al-Si composites JOM. ,vol. 49, pp. 31- 37 ,(1997) , 10.1007/S11837-997-0008-5
Ibrahim Ciftci, Mehmet Turker, Ulvi Seker, CBN cutting tool wear during machining of particulate reinforced MMCs Wear. ,vol. 257, pp. 1041- 1046 ,(2004) , 10.1016/J.WEAR.2004.07.005
M. El-Gallab, M. Sklad, Machining of Al/SiC particulate metal-matrix composites Journal of Materials Processing Technology. ,vol. 83, pp. 151- 158 ,(1998) , 10.1016/S0924-0136(98)00054-5
K. Weinert, W. König, A Consideration of Tool Wear Mechanism when Machining Metal Matrix Composites (MMC) CIRP Annals. ,vol. 42, pp. 95- 98 ,(1993) , 10.1016/S0007-8506(07)62400-7
Xiaoping Li, W.K.H Seah, Tool wear acceleration in relation to workpiece reinforcement percentage in cutting of metal matrix composites Wear. ,vol. 247, pp. 161- 171 ,(2001) , 10.1016/S0043-1648(00)00524-X