Three-body abrasive wear behavior of short jute fiber reinforced epoxy composites

作者: Vivek Mishra , Sandhyarani Biswas , None

DOI: 10.1002/PC.23178

关键词: Abrasion (mechanical)Natural rubberComposite numberAbrasiveMaterials scienceFiberComposite materialTaguchi orthogonal arrayEpoxyMaterial removal

摘要: In present investigation, the three-body abrasive wear behavior of short jute fiber reinforced epoxy composites was studied. The effect various parameters such as loading, sliding velocity, normal load, and size on rate composite has been analyzed. Abrasive study carried out using a dry sand/rubber wheel abrasion tester. friction characteristics these are analyzed successfully Taguchi orthogonal array analysis variance. experimental reveals that have greater influence specific composites. results show decreases with increase in velocity whereas, load increases. also revealed coefficient increases up to certain value than well velocity. worn surfaces abraded specimens were examined SEM understand mechanism involved material removal. POLYM. COMPOS., 2014. © 2014 Society Plastics Engineers

参考文章(24)
Navin Chand, Somit Neogi, Mechanism of material removal during three-body abrasion of FRP composite Tribology Letters. ,vol. 4, pp. 81- 85 ,(1998) , 10.1023/A:1019138718283
Liang Fang, Weimin Liu, Daoshan Du, Xiaofeng Zhang, Qunji Xue, Predicting three-body abrasive wear using Monte Carlo methods Wear. ,vol. 256, pp. 685- 694 ,(2004) , 10.1016/S0043-1648(03)00464-2
B.F. Yousif, N.S.M. El-Tayeb, Wear characteristics of thermoset composite under high stress three-body abrasive Tribology International. ,vol. 43, pp. 2365- 2371 ,(2010) , 10.1016/J.TRIBOINT.2010.08.010
Sangita Mohapatra, Sisir Mantry, S. K. Singh, Performance Evaluation of Glass-Epoxy-TiC Hybrid Composites Using Design of Experiment Journal of Composites. ,vol. 2014, pp. 1- 9 ,(2014) , 10.1155/2014/670659
A.C. McGee, C.K.H. Dharan, I. Finnie, Abrasive wear of graphite fiber-reinforced polymer composite materials Wear. ,vol. 114, pp. 97- 107 ,(1987) , 10.1016/0043-1648(87)90019-6
R. Ramesh, Kishore, R.M.V.G.K. Rao, Dry wear studies on glass-fibre-reinforced epoxy composites Wear. ,vol. 89, pp. 131- 136 ,(1983) , 10.1016/0043-1648(83)90238-7
Sisir Mantry, Alok Satapathy, Alok Kumar Jha, Saroj Kumar Singh, Amar Patnaik, None, Preparation, characterization and erosion response of jute-epoxy composites reinforced with SiC derived from rice husk International Journal of Plastics Technology. ,vol. 15, pp. 69- 76 ,(2011) , 10.1007/S12588-011-9007-Z
Bhanu K. Goriparthi, K.N.S. Suman, Nalluri Mohan Rao, Effect of fiber surface treatments on mechanical and abrasive wear performance of polylactide/jute composites Composites Part A-applied Science and Manufacturing. ,vol. 43, pp. 1800- 1808 ,(2012) , 10.1016/J.COMPOSITESA.2012.05.007