On the accurate calibration of an electrochemical oxygen meter in the 10-7 bar range
作者： C. M. Mari , S. Pizzini , T. A. Giorgi , L. Rosai , M. Borghi
DOI: 10.1007/BF00618988
关键词: Pyrolysis 、 Analytical chemistry 、 Chemistry 、 Bar (music) 、 Electrochemistry 、 Hydrogen 、 Getter 、 Oxygen 、 Calibration 、 Metre
摘要: A method for the accurate standardization of an electrochemical oxygen meter, in 10−6-10−7 bar range is described. The based on use leak and a chemical getter pump. In this manner problems connected with traces hydrogen, originating from pyrolysis water, unknown origin are overcome.
springer.com
sci-hub.se 参考文章(5)
J. Fouletier, H. Seinera, M. Kleitz, Measurement and regulation of oxygen content in selected gases using solid electrolyte cells. I. Discontinuous use of gauges Journal of Applied Electrochemistry. ,vol. 4, pp. 305- 315 ,(1974) , 10.1007/BF00608972
C. B. Alcock, S. Zador, Electrolytic removal of oxygen from gases by means of solid electrolyte Journal of Applied Electrochemistry. ,vol. 2, pp. 289- 299 ,(1972) , 10.1007/BF00615276
L. Rosai, M. Borghi, Purification of rare gases and the measurement of low residual impurity levels Journal of Vacuum Science and Technology. ,vol. 11, pp. 347- 349 ,(1974) , 10.1116/1.1318616
T. H. Etsell, S. N. Flengas, The determination of oxygen in gas mixtures by electromotive force measurements using solid oxide electrolytes Metallurgical and Materials Transactions B-process Metallurgy and Materials Processing Science. ,vol. 3, pp. 27- 36 ,(1972) , 10.1007/BF02680581
J. Fouletier, G. Vitter, M. Kleitz, Measurement and regulation of oxygen content in gases using solid electrolyte cells. III. Oxygen pump-gauge Journal of Applied Electrochemistry. ,vol. 5, pp. 111- 120 ,(1975) , 10.1007/BF00613213