Hydrogen production by ethanol steam reforming: A study of Co- and Ce-based catalysts over FeCrAlloy monoliths

作者: Yelisbeth Escalante , Agustín E. Galetti , Manuel F. Gómez , Octavio J. Furlong , Marcelo S. Nazzarro

DOI: 10.1016/J.IJHYDENE.2020.05.188

关键词: MonolithCalcinationSpinelChemical engineeringHydrogen productionSubstrate (chemistry)Steam reformingMaterials scienceCoatingCatalysis

摘要: Abstract Co- and Ce-based structured catalysts deposited on FeCrAlloy monoliths have been prepared. A new two-step strategy for coating the monolith is used: (i) first, a MgAl2O4 spinel layer generated substrate, (ii) then, Co Ce are incorporated in two different molar ratios by conventional wet impregnation method. The formed from solution of colloidal alumina Mg(NO3)2, with an apparent viscosity around 3300 mPa s. results indicate that homogeneous excellent adherence obtained after immersions calcination at 700 °C. Both active steam reforming ethanol 650 °C. system Co/Ce ratio 3.7 exhibits best performance high stability. complete conversion hydrogen selectivity 95% reaction cycles 36 h each intermediate regeneration.

参考文章(55)
Agustín E. Galetti, Manuel F. Gomez, Luis A. Arrúa, M. Cristina Abello, Hydrogen production by ethanol reforming over NiZnAl catalysts: Influence of Ce addition on carbon deposition Applied Catalysis A-general. ,vol. 348, pp. 94- 102 ,(2008) , 10.1016/J.APCATA.2008.06.039
Paula Osorio-Vargas, Cristian H. Campos, Rufino M. Navarro, Jose L.G. Fierro, Patricio Reyes, Improved ethanol steam reforming on Rh/Al2O3 catalysts doped with CeO2 or/and La2O3: Influence in reaction pathways including coke formation Applied Catalysis A-general. ,vol. 505, pp. 159- 172 ,(2015) , 10.1016/J.APCATA.2015.07.037
Pedro Avila, Mario Montes, Eduardo E. Miró, Monolithic reactors for environmental applications: A review on preparation technologies Chemical Engineering Journal. ,vol. 109, pp. 11- 36 ,(2005) , 10.1016/J.CEJ.2005.02.025
L.C. Almeida, F.J. Echave, O. Sanz, M.A. Centeno, J.A. Odriozola, M. Montes, Washcoating of metallic monoliths and microchannel reactors Studies in Surface Science and Catalysis. ,vol. 175, pp. 25- 33 ,(2010) , 10.1016/S0167-2991(10)75004-7
Ana M. Tarditi, Noelia Barroso, Agustín E. Galetti, Luis A. Arrúa, Laura Cornaglia, María C. Abello, XPS study of the surface properties and Ni particle size determination of Ni-supported catalysts Surface and Interface Analysis. ,vol. 46, pp. 521- 529 ,(2014) , 10.1002/SIA.5549
Albert Casanovas, Maria Roig, Carla de Leitenburg, Alessandro Trovarelli, Jordi Llorca, Ethanol steam reforming and water gas shift over Co/ZnO catalytic honeycombs doped with Fe, Ni, Cu, Cr and Na International Journal of Hydrogen Energy. ,vol. 35, pp. 7690- 7698 ,(2010) , 10.1016/J.IJHYDENE.2010.05.099
F.J. Echave, O. Sanz, M. Montes, Washcoating of microchannel reactors with PdZnO catalyst for methanol steam reforming Applied Catalysis A-general. ,vol. 474, pp. 159- 167 ,(2014) , 10.1016/J.APCATA.2013.07.058
L GIANI, C CRISTIANI, G GROPPI, E TRONCONI, Washcoating method for Pd/γ-Al2O3 deposition on metallic foams Applied Catalysis B-environmental. ,vol. 62, pp. 121- 131 ,(2006) , 10.1016/J.APCATB.2005.07.003
P. Rybak, B. Tomaszewska, A. Machocki, W. Grzegorczyk, A. Denis, Conversion of ethanol over supported cobalt oxide catalysts Catalysis Today. ,vol. 176, pp. 14- 20 ,(2011) , 10.1016/J.CATTOD.2011.06.015
Albert Casanovas, Carla de Leitenburg, Alessandro Trovarelli, Jordi Llorca, Catalytic monoliths for ethanol steam reforming Catalysis Today. ,vol. 138, pp. 187- 192 ,(2008) , 10.1016/J.CATTOD.2008.05.028