MACHINING OF MMCs: A REVIEW
作者： Suhasini Gururaja , Mamidala Ramulu , William Pedersen
DOI: 10.1080/10910344.2012.747897
关键词: Material system 、 Aluminum matrix composites 、 Machining 、 Machinability 、 Low melting point 、 Tool wear 、 Chip formation 、 Low density 、 Metallurgy 、 Materials science
摘要: … vis-à-vis tool life, tool wear, machinability and understanding chip … Most of the studies discussed in this review will focus on … PCD tools were found to outperform all other tool materials in …
sci-hub.se 参考文章(97)
Mariam S. El-Gallab, Mateusz P. Sklad, Machining of aluminum/silicon carbide particulate metal matrix composites: Part IV. Residual stresses in the machined workpiece Journal of Materials Processing Technology. ,vol. 152, pp. 23- 34 ,(2004) , 10.1016/J.JMATPROTEC.2004.01.061
S. Barnes, I. R. Pashby, A. B. Hashim, Effect of heat treatment on the drilling performance of aluminium/SiC MMC Applied Composite Materials. ,vol. 6, pp. 121- 138 ,(1999) , 10.1023/A:1008853525975
S. R. Ghadimzadeh, A. Jawaid, Stuart Barnes, Drilling of particulate silicon carbide metal matrix composites, machining of composite materials ,(1992)
Laxmikanth Keni, Vasanth Kamath, Raghuvir B Pai, Raviraj Shetty, EXPERIMENTAL AND ANALYTICAL STUDY ON CHIP FORMATION MECHANISM IN MACHINING OF DRACs Asian Research Publishing Network. ,(2008)
W.S. Lau, T.M. Yue, T.C. Lee, W.B. Lee, Un-conventional machining of composite materials Journal of Materials Processing Technology. ,vol. 48, pp. 199- 205 ,(1995) , 10.1016/0924-0136(94)01650-P
J.T. Lin, D. Bhattacharyya, C. Lane, Machinability of a silicon carbide reinforced aluminium metal matrix composite Wear. pp. 883- 888 ,(1995) , 10.1016/0043-1648(95)90211-2
J.Paulo Davim, C.A Conceição António, Optimal drilling of particulate metal matrix composites based on experimental and numerical procedures International Journal of Machine Tools and Manufacture. ,vol. 41, pp. 21- 31 ,(2001) , 10.1016/S0890-6955(00)00071-7
John Monaghan, Factors Affecting the Machinability of Al/SiC Metal-Matrix Composites Key Engineering Materials. ,vol. 138-140, pp. 545- 574 ,(1997) , 10.4028/WWW.SCIENTIFIC.NET/KEM.138-140.545
A. Pramanik, L.C. Zhang, J.A. Arsecularatne, Prediction of cutting forces in machining of Metal Matrix Composites International Journal of Machine Tools & Manufacture. ,vol. 46, pp. 1795- 1803 ,(2006) , 10.1016/J.IJMACHTOOLS.2005.11.012
N. P. Hung, S. H. Yeo, K. K. Lee, K. J. Ng, Chip Formation in Machining Particle-Reinforced Metal Matrix Composites Materials and Manufacturing Processes. ,vol. 13, pp. 85- 100 ,(1998) , 10.1080/10426919808935221