CRANK CASE STRUCTURE OF INTERNAL COMBUSTION ENGINE
作者： Harada Makoto , Sugiyama Masanori , Nagata Hiroki , Hakamata Teppei
DOI:
关键词: Internal combustion engine 、 Mechanics 、 Physics 、 Starter 、 Breather 、 Crank 、 Crankcase 、 Cylinder block
摘要: PROBLEM TO BE SOLVED: To provide a crank case structure of an internal combustion engine in which starter motor disposed on is hardly affected by heat, and at comparatively low position.SOLUTION: In engine, breather chamber (41) formed rear part cases (30, 50) state being separated from cylinder block (3) projecting upward, (20) above upper wall regions (34, 54) the between (41), slit recessed portions (34s, 54s) respectively biting to vicinity split faces (32a, 52a) right left outer side toward 52a), are below (20).
lens.org 参考文章(18)
Kiyohito Takano, Yuichi Kawamoto, Dry-sump lubrication type four-stroke cycle engine ,(2003)
Kiyohito Takano, Lubricating oil feeding structure of engine ,(2010)
Masafumi Taki, Hisashi Sakuyama, Engine for vehicle ,(2009)
Tokuo Abe, 徳男 阿部, Lubricating structure for engine ,(2008)
Hayato Yamashiro, 明 高橋, 隼人 山代, Akira Takahashi, Case cover structure of internal combustion engine ,(2010)
Kobayashi Manabu, Honma Akinori, POWER UNIT FOR MOTOR SCOOTER TYPE VEHICLE ,(1995)
Kawamoto Yuichi, Kanazawa Tomohiro, DRYSUMP TYPE FOUR-CYCLE ENGINE ,(2003)
Takahashi Takeshi, CRANK CASE STRUCTURE OF ENGINE ,(1995)
Suzaki Sumio, Daito Masamune, Unuki Yasushi, BREATHER DEVICE FOR INTERNAL COMBUSTION ENGINE ,(2009)
Sato Tomoyasu, Kanbe Takashi, MOUNTING STRUCTURE OF STARTER MOTOR ,(2004)