Vehicle on-board electric power system
作者： Christian Arndt , Alfons Graf
DOI:
关键词: Voltage regulation 、 Voltage optimisation 、 Pre-charge 、 Electrical engineering 、 Power factor 、 Voltage 、 Switched-mode power supply 、 Electrical load 、 Engineering 、 Single-phase electric power
摘要: A vehicle on-board electric power system is disclosed including at least one field-effect-controlled transistor which applies a supply voltage VBB to load when actuated by logic circuit. The has drain-source breakdown VDS with positive temperature coefficient TKDS and provided clamping means for protecting against overvoltages VO occurring in the system. VCLAMP TKCLAMP≈TKDS, being lower than or equal an anticipated maximum overvoltage VOmax
lens.org 参考文章(16)
Peter Norton, Dual or single voltage vehicular power supply with improved switch driver and load dump ,(1989)
Izak Bencuya, Hamza Yilmaz, Transistor with voltage clamp ,(1990)
A. Castellazzi, Y.C. Gerstenmaier, R. Kraus, G.K.M. Wachutka, Reliability analysis and modeling of power MOSFETs in the 42-V-PowerNet IEEE Transactions on Power Electronics. ,vol. 21, pp. 603- 612 ,(2006) , 10.1109/TPEL.2006.872382
Richard H. Baker, Field effect regulator with stable feedback loop ,(1984)
John P. Phipps, Stephen P. Robb, Michael D. Gadberry, Avalanche stress protected semiconductor device having variable input impedance ,(1990)
Peter Sommer, Jenoe Tihanyi, Over-voltage protection device for semiconductor switch in load-circuit e.g. for automobile technology ,(1999)
Thomas Farkas, Overcurrent protection for power converters ,(2006)
Naoki Kumagai, Semiconductor device including overvoltage protective circuit ,(1993)
Daniel Quessada, Jean Barret, Protection structure against overvoltages for a vertical semiconductor device ,(1993)
Ryu Saitoh, Akira Nishiura, Masahito Otsuki, Protective diode for transistor ,(1995)