Fitting structure of cylindrical member
作者： Tsuyoshi Yamaguchi
DOI:
关键词: Cylinder 、 Geometry 、 Flange 、 Materials science
摘要: A recess is formed in an outer circumferential surface of a first fitting cylinder. flange and second cylinder are provided at one end cylindrical member which part dust cover. sealing attached to the flange. protruding portion on inner The strongly pressed by state where fitted into cylinder, each other. Due this structure, up-and-down movement both cylinders limited, pressed, thereby maintaining sealing.
lens.org 参考文章(13)
洋 浜田, Hiroshi Hamada, Toshio Isono, 基彦 服部, Motohiko Hattori, 敏雄 礒野, Column hole cover structure of the steering shaft ,(1997)
Yoshihisa Kato, 嘉久 加藤, Yoshitaka Kuwajima, 喜崇 桑嶋, Column hole cover ,(1997)
Yoshitaka Tsuboi, 義隆 坪井, Hisao Ubukata, 久夫 生方, Sealing device for steering device ,(2004)
Yoshitaka Tsuboi, 義隆 坪井, Hisao Ubukata, 久夫 生方, Vehicle body sealing structure for steering device ,(2004)
Yasui Yoshiyuki, Tanaka Wataru, Kato Hiroaki, Asano Kenji, Ono Hidekazu, Momiyama Mineichi, Murakishi Yuji, ELECTRIC POWER STEERING APPARATUS ,(2003)
Gerald A. Babuder, Tube coupling with gasket retainer ,(1990)
Teruya Fujiwara, Noboru Yamamoto, Hirohisa Suzuki, Seizou Furukawa, Column hole cover ,(2004)
David Thomas Bowles, Ronald Peter Pardy, Fuel tank connector ,(1996)
Dirk Sickert, Birger Assmann, Markus Braun, Joachim Heidel, Vehicle body seal for a steering column leadthrough ,(2008)
Albert P Meriano, Sealed joint employing pressure loaded and mechanically loaded seal ,(1964)