Influence of preheating on grindability of coal
作者： J. Lytle , N. Choi , K. Prisbrey
DOI: 10.1016/0301-7516(92)90067-7
关键词:
摘要: Abstract Enormous quantities of coal must be ground as feed to power generation facilities. The energy cost grinding is significant at 5 15 kWh/ton. If grindability could increased by preheating the with waste heat, costs reduced. objective this work was determine how affected preheating. method use population balance models interpret results before and after a heat treatment. Simulation locked cycle tests gave 40% increase in grindability. Approximately saving can expected. By using for treatment, targeted savings would maintained.
elsevier.com
sci-hub.se 参考文章(11)
O Trass, G Papachristodoulou, V R Koka, BENEFICIATION AND FINE GRINDING OF COAL FOR SLURRY FUEL PREPARATION ,(1985)
John M. Lytle, J. Leland Daniel, Keith A. Prisbrey, Effect of microstructure on the size and shape of coal particles during comminution Fuel. ,vol. 62, pp. 1304- 1309 ,(1983) , 10.1016/S0016-2361(83)80014-3
K.A. Lewis, M. Pearl, P. Tucker, Computer simulation of the bond grindability test Minerals Engineering. ,vol. 3, pp. 199- 206 ,(1990) , 10.1016/0892-6875(90)90092-P
J.M. Lytle, K.A. Prisbrey, Material-depednent non-linear modeling of fine coal grinding Powder Technology. ,vol. 38, pp. 93- 97 ,(1984) , 10.1016/0032-5910(84)80037-6
R.K. Dutkiewicz, S.F. Scieszka, R.H. von Fintel, A study of the energy-size reduction relationship in impact crushing of coal Powder Technology. ,vol. 49, pp. 83- 86 ,(1986) , 10.1016/0032-5910(86)85009-4
N. Magdalinović, A procedure for rapid determination of the Bond work index International Journal of Mineral Processing. ,vol. 27, pp. 125- 132 ,(1989) , 10.1016/0301-7516(89)90010-0
P.C. Kapur, D.W. Fuerstenau, Simulation of locked-cycle grinding tests using multicomponent feeds Powder Technology. ,vol. 58, pp. 39- 48 ,(1989) , 10.1016/0032-5910(89)80005-1
ROBIN P. GARDNER, KURUVILLA VERGHESE, A REVIEW OF THE MATHEMATICAL APPROACHES TO NONLINEAR GRINDING AND A SUGGESTED GENERAL TREATMENT FOR ENVIRONMENTAL NONLINEARITIES BASED ON THE USE OF INFLUENCE FUNCTIONS Particulate Science and Technology. ,vol. 2, pp. 101- 120 ,(1984) , 10.1080/02726358408906398
REED S. C. ROGERS, KENNETH A. BRAME, LEONARD G. AUSTIN, Simulation for the Design of Ball Mills for Coal Grinding Coal Preparation. ,vol. 5, pp. 71- 83 ,(1987) , 10.1080/07349348708945557
S. K. Kawatra, T. C. Eisele, D. X. Zhang, M. T. Rusesky, Temperature effect on grinding circuit performance Mining, Metallurgy & Exploration. ,vol. 6, pp. 85- 87 ,(1989) , 10.1007/BF03402532