Tribological and corrosion Behavior of Duplex Coated AISI 316L using plasma based ion implantation and deposItion
作者： Laura S. Vaca , Juan P. Quintana , Daniel Vega , Adriana Márquez , Sonia P. Brühl
DOI: 10.1016/J.MTCOMM.2020.101892
关键词:
摘要: Abstract The implementation of a duplex process, which combines plasma nitriding with hard coatings obtained by cathodic arc, on stainless steel substrates has faced adhesion problems that affected the wear and corrosion behavior treated surfaces. One variation arc could improve adhesion, is its combination ion implantation. This work presents results TiTiN bilayer deposition combined implantation (PBIID one group samples was coated using same experimental device substrate at floating potential other commercial PVD system. were characterized SEM, XRD, nanoindentation. evaluated Scratch Test Rockwell C indentation. resistance analyzed pin-on-disk test means anodic polarization tests in NaCl solution, as well Salt Spray Fog Test. PBII&D showed better while TiN presented smallest volume loss, but delamination inside around track evidenced problems. Corrosion improved all benchmarked against nitride substrates, processes offered protection.
sci-hub.st 参考文章(38)
Kenneth Holmberg, Allan Matthews, Coatings Tribology: Properties, Mechanisms, Techniques and Applications in Surface Engineering ,(2009)
Eugenia L. Dalibon, Mauro Moscatelli, Silvia Simison, Lisandro Escalada, Amado Cabo, Carlos Lasorsa, Sonia P. Brühl, Corrosion behaviour of a SiOxNy coated and nitrided PH stainless steel Procedia Materials Science. ,vol. 8, pp. 29- 38 ,(2015) , 10.1016/J.MSPRO.2015.04.045
I. Zhirkov, A. Petruhins, J. Rosen, Effect of cathode composition and nitrogen pressure on macroparticle generation and type of arc discharge in a DC arc source with Ti–Al compound cathodes Surface & Coatings Technology. ,vol. 281, pp. 20- 26 ,(2015) , 10.1016/J.SURFCOAT.2015.09.030
Wolfgang Tillmann, Evelina Vogli, Siavash Momeni, Improvement of press dies used for the production of diamond composites by means of DUPLEX-PVD-coatings Surface & Coatings Technology. ,vol. 205, pp. 1571- 1577 ,(2010) , 10.1016/J.SURFCOAT.2010.08.048
L. Escalada, J. Lutz, S.P. Brühl, M. Fazio, A. Márquez, S. Mändl, D. Manova, S.N. Simison, Microstructure and corrosion behavior of AISI 316L duplex treated by means of ion nitriding and plasma based ion implantation and deposition Surface & Coatings Technology. ,vol. 223, pp. 41- 46 ,(2013) , 10.1016/J.SURFCOAT.2013.02.025
A. Khorsand Zak, W.H. Abd. Majid, M.E. Abrishami, Ramin Yousefi, X-ray analysis of ZnO nanoparticles by Williamson–Hall and size–strain plot methods Solid State Sciences. ,vol. 13, pp. 251- 256 ,(2011) , 10.1016/J.SOLIDSTATESCIENCES.2010.11.024
B D Beake, V M Vishnyakov, J S Colligon, Nano-impact testing of TiFeN and TiFeMoN films for dynamic toughness evaluation Journal of Physics D. ,vol. 44, pp. 085301- ,(2011) , 10.1088/0022-3727/44/8/085301
Bojan Podgornik, Jože Vižintin, Tribology of thin films and their use in the field of machine elements Vacuum. ,vol. 68, pp. 39- 47 ,(2002) , 10.1016/S0042-207X(02)00282-8
A Leyland, A Matthews, On the significance of the H/E ratio in wear control: a nanocomposite coating approach to optimised tribological behaviour Wear. ,vol. 246, pp. 1- 11 ,(2000) , 10.1016/S0043-1648(00)00488-9
Chenglong Liu, Guoqiang Lin, Dazhi Yang, Min Qi, In vitro corrosion behavior of multilayered Ti/TiN coating on biomedical AISI 316L stainless steel Surface & Coatings Technology. ,vol. 200, pp. 4011- 4016 ,(2006) , 10.1016/J.SURFCOAT.2004.12.015