Pitting and EPR studies of ion implanted plain and sensitized 304 stainless steel
作者： M.R. Nair , S. Venkatraman , D.C. Kothari , K.B. Lal , R. Raman
DOI: 10.1016/0168-583X(88)90364-3
关键词:
摘要: Abstract 30 keV N2+, Ti+ and N2+ followed by ions were implanted at room temperature on plain sensitized 304 stainless steel (304 SS) foils. The ion fluences ranged from 1 × 1017 ions/cm2 to 5 ions/cm2. Pitting studies in quiescent non-dearated 3.5 wt.% NaCl electrolyte Electrolytic Potentiokinetic Reactivation (EPR) a standard of KSCN + H2SO4 carried out plain, SS In general, the localized corrosion behaviour deteriorated implantation irrespective nature implant species their employed this work. However, showed an improvement. benefits accrued was dependent fluences. An attempt has been made explain why interact differently, with consequent difference behaviour, when substrate is state.
harvard.edu
elsevier.com
sci-hub.se 参考文章(16)
A. John Sedriks, Corrosion of Stainless Steels ,(1979)
I. L. Singer, Carburization of steel surfaces during implantation of Ti ions at high fluences Journal of Vacuum Science and Technology. ,vol. 1, pp. 419- 422 ,(1983) , 10.1116/1.571934
D.M. Follstaedt, L.E. Pope, J.A. Knapp, S.T. Picraux, F.G. Yost, The microstructure of type 304 stainless steel implanted with titanium and carbon and its relation to friction and wear tests Thin Solid Films. ,vol. 107, pp. 259- 267 ,(1983) , 10.1016/0040-6090(83)90405-4
M.R Nair, D.C Kothari, A.A Rangwala, K.B Lal, P.D Prabhawalkar, P.M Raole, X-ray photoelectron spectroscopy studies of hard coatings formed by titanium implantation on 304 stainless steel Thin Solid Films. ,vol. 141, pp. 59- 69 ,(1986) , 10.1016/0040-6090(86)90319-6
C. R. RAREY, A. H. ARONSON, Pitting Corrosion of Sensitized Ferritic Stainless Steel Corrosion. ,vol. 28, pp. 255- 258 ,(1972) , 10.5006/0010-9312-28.7.255
R. Štefec, F. Franz, A. Holeček, Effect of Heat Treatment on Pitting Corrosion of austenitic Cr‐Ni‐Mo steels in sodium chloride solution Materials and Corrosion-werkstoffe Und Korrosion. ,vol. 30, pp. 189- 197 ,(1979) , 10.1002/MACO.19790300305
R. O. Adams, A review of the stainless steel surface Journal of Vacuum Science and Technology. ,vol. 1, pp. 12- 18 ,(1983) , 10.1116/1.572301
J.N. Wanklyn, The role of molybdenum in the crevice corrosion of stainless steels Corrosion Science. ,vol. 21, pp. 211- 225 ,(1981) , 10.1016/0010-938X(81)90031-7
PD Prabhawalkar, PM Raole, DC Kothari, MR Nair, XPS studies at various depths of low energy N2+ ions implanted on 304 stainless steel Vacuum. ,vol. 36, pp. 817- 820 ,(1986) , 10.1016/0042-207X(86)90118-1
E. Johnson, T. Wohlenberg, W. A. Grant, Crystalline phase transitions produced by ion implantation Phase Transitions. ,vol. 1, pp. 23- 33 ,(1979) , 10.1080/01411597908213182