Recuperator dynamic performance: Experimental investigation with a microgas turbine test rig

作者: Mario L. Ferrari , Alessandro Sorce , Matteo Pascenti , Aristide F. Massardo

DOI: 10.1016/J.APENERGY.2011.07.016

关键词:

摘要: Abstract The aim of this work is the experimental analysis steady-state and transient behavior a primary surface recuperator installed in 100 kW commercial microgas turbine (mGT). machine integrated an innovative test rig for high temperature fuel cell hybrid system emulation. It was designed by Thermochemical Power Group (TPG), at University Genoa, within framework Felicitas LARGE-SOFC European Integrated Projects. flexibility exploited to perform tests on operating standard cycle. Attention mainly focused its performance conditions (start-up operations load rejection tests). Start-up were carried out both electrical grid-connected stand-alone conditions, with different control strategies. response due strategy boundary variation because influence component life consumption.

参考文章(22)
Matteo Pascenti, Mario L. Ferrari, Loredana Magistri, Aristide F. Massardo, Micro Gas Turbine Based Test Rig for Hybrid System Emulation ASME Turbo Expo 2007: Power for Land, Sea, and Air. pp. 7- 15 ,(2007) , 10.1115/GT2007-27075
Colin F. McDonald, Low-cost compact primary surface recuperator concept for microturbines Applied Thermal Engineering. ,vol. 20, pp. 471- 497 ,(2000) , 10.1016/S1359-4311(99)00033-2
Hubert Antoine, Luc Prieels, The ACTE Spiral Recuperator for Gas Turbine Engines ASME Turbo Expo 2002: Power for Land, Sea, and Air. pp. 1025- 1031 ,(2002) , 10.1115/GT2002-30405
S. Förster, M. Kleemann, Compact Metallic and Ceramic Recuperators for Gas Turbines Volume 1A: General. ,(1978) , 10.1115/78-GT-62
S.R. Allen, G.P. Hammond, M.C. McManus, Prospects for and barriers to domestic micro-generation: A United Kingdom perspective Applied Energy. ,vol. 85, pp. 528- 544 ,(2008) , 10.1016/J.APENERGY.2007.09.006
D. Missirlis, K. Yakinthos, A. Palikaras, K. Katheder, A. Goulas, Experimental and numerical investigation of the flow field through a heat exchanger for aero-engine applications International Journal of Heat and Fluid Flow. ,vol. 26, pp. 440- 458 ,(2005) , 10.1016/J.IJHEATFLUIDFLOW.2004.10.003
Colin F. McDonald, Colin Rodgers, Ceramic Recuperator and Turbine: The Key to Achieving a 40 Percent Efficient Microturbine ASME Turbo Expo 2005: Power for Land, Sea, and Air. pp. 963- 971 ,(2005) , 10.1115/GT2005-68644
C.F. McDonald, A Review on Heat Recovery Exchangers for Very Small Engines International Journal of Turbo & Jet-engines. ,vol. 13, ,(1996) , 10.1515/TJJ.1996.13.4.239
James Kesseli, Thomas Wolf, James Nash, Steven Freedman, Micro, Industrial, and Advanced Gas Turbines Employing Recuperators ASME Turbo Expo 2003, collocated with the 2003 International Joint Power Generation Conference. pp. 789- 794 ,(2003) , 10.1115/GT2003-38938
Rory A. Roberts, Jack Brouwer, Eric Liese, Randall S. Gemmen, Development of controls for dynamic operation of carbonate fuel cell-gas turbine hybrid systems ASME Turbo Expo 2005: Power for Land, Sea, and Air. pp. 325- 331 ,(2005) , 10.1115/GT2005-68774