Integration of a 5-axis Spline Interpolation Controller in an Open CNC System
作者： Yongzhang Wang , Yuan Liu , Zhenyu Han , Zhongxi Shao
DOI: 10.1016/S1000-9361(08)60090-4
关键词:
摘要: … of this format are developed for the control of 5-axis machine tools in the authors-… tilting rotary table type 5-axis CNC machine tool which has three linear axes X, Y, and Z, and two rotary …
cyberleninka.org
elsevier.com
sci-hub.se 参考文章(20)
Kaan Erkorkmaz, Yusuf Altintas, High speed CNC system design. Part I: jerk limited trajectory generation and quintic spline interpolation International Journal of Machine Tools & Manufacture. ,vol. 41, pp. 1323- 1345 ,(2001) , 10.1016/S0890-6955(01)00002-5
M.-Y. Cheng, M.-C. Tsai, J.-C. Kuo, Real-time NURBS command generators for CNC servo controllers International Journal of Machine Tools & Manufacture. ,vol. 42, pp. 801- 813 ,(2002) , 10.1016/S0890-6955(02)00015-9
Xiong-bo MA, Zhen-yu HAN, Yong-zhang WANG, Hong-ya FU, Development of a PC-based Open Architecture Software-CNC System Chinese Journal of Aeronautics. ,vol. 20, pp. 272- 281 ,(2007) , 10.1016/S1000-9361(07)60044-2
S.-S. Yeh, P.-L. Hsu, The speed-controlled interpolator for machining parametric curves Computer-aided Design. ,vol. 31, pp. 349- 357 ,(1999) , 10.1016/S0010-4485(99)00035-4
Yong-zhang WANG, Liang-ji CHEN, A Real-time NURBS Surface Interpolator for 5-axis Surface Machining Chinese Journal of Aeronautics. ,vol. 18, pp. 263- 272 ,(2005) , 10.1016/S1000-9361(11)60308-7
Syh-Shiuh Yeh, Pau-Lo Hsu, Adaptive-feedrate interpolation for parametric curves with a confined chord error Computer-aided Design. ,vol. 34, pp. 229- 237 ,(2002) , 10.1016/S0010-4485(01)00082-3
Zhang Deli, Zhou Laishui, Intelligent NURBS Interpolator Based on the Adaptive Feedrate Control Chinese Journal of Aeronautics. ,vol. 20, pp. 469- 474 ,(2007) , 10.1016/S1000-9361(07)60069-7
C. G. JENSEN, D. C. ANDERSON, A review of numerically controlled methods for finish-sculptured-surface machining Iie Transactions. ,vol. 28, pp. 30- 39 ,(1996) , 10.1080/07408179608966250
Tsehaw Yong, Ranga Narayanaswami, A parametric interpolator with confined chord errors, acceleration and deceleration for NC machining Computer-aided Design. ,vol. 35, pp. 1249- 1259 ,(2003) , 10.1016/S0010-4485(03)00043-5
Hai-Yin Xu, Linear and angular feedrate interpolation for planar implicit curves Computer-Aided Design. ,vol. 35, pp. 301- 317 ,(2003) , 10.1016/S0010-4485(01)00218-4