Effects of temperature on the response of composite bolted joints
作者： Y. Takao
DOI: 10.1533/9780857094926.1.295
关键词:
摘要: Abstract: This chapter considers the effects of temperature on a mechanical joint composite materials under static loading. Following presentation results literature survey, response pin and bolt joints are described including an experimental method specific to effects, load-deformation curves bearing strength. Damage (macroscopic surface damage evolution microscopic damage) is explained in detail for both cases. The numerical methods previous related further research this topic recommended.
elsevier.com
sci-hub.se 参考文章(33)
DJ. Wilkins, Environmental Sensitivity Tests of Graphite-Epoxy Bolt Bearing Properties ASTM special technical publications. pp. 497- 513 ,(1977) , 10.1520/STP26962S
文学 汪, 憲芳 平野, Wen-Xue Wang, Yoshihiro Takao, 善裕 高雄, ヨシヒロ タカオ, ブンガク オウ, ノリヨシ ヒラノ, Noriyoshi Hirano, The Effect of Temperature on Bearing Strength of CFRP Bolted Joint with Washer Constraining Reports of Research Institute for Applied Mechanics,Kyushu University. ,vol. 142, pp. 21- 27 ,(2012)
RL Ramkumar, EW Tossavainen, Strength and Lifetime of Bolted Laminates ASTM International. ,(1986) , 10.1520/STP29063S
P. P. Camanho, S. Bowron, F. L. Matthews, Failure Mechanisms in Bolted CFRP Journal of Reinforced Plastics and Composites. ,vol. 17, pp. 205- 233 ,(1998) , 10.1177/073168449801700302
Claudio Scarponi, Giuseppe Marini, Paolo Montanari, The importance of the temperature and lateral pressure on the CFRP joints strength under uniaxial loading Journal of Reinforced Plastics and Composites. ,vol. 16, pp. 825- 847 ,(1997) , 10.1177/073168449701600904
JH Crews, RVA Naik, Failure analysis of a graphite/epoxy laminate subjected to bolt-bearing loads ASTM special technical publications. pp. 115- 133 ,(1986) , 10.1520/STP19983S
Toshiyuki Shimokawa, Yasumasa Hamaguchi, Yoshiaki Kakuta, Hisaya Katoh, Tomio Sanda, Hiroshi Mizuno, Yasuhiro Toi, Effect of Isothermal Aging on Ultimate Strength of High-Temperature Composite Materials for SST Structures: Journal of Composite Materials. ,vol. 33, pp. 1104- 1118 ,(1999) , 10.1177/002199839903301203
Hyoung Soo Kim, Wen-Xue Wang, Yoshihiro Takao, Evaluation by FEM of temperature-dependent damage behavior in quasi-isotropic carbon/epoxy laminates Advanced Composite Materials. ,vol. 8, pp. 247- 257 ,(1999) , 10.1163/156855199X00245
Scot D. Andrews, Ozden O. Ochoa, Steve D. Owens, The effects of fastener hole defects Journal of Composite Materials. ,vol. 27, pp. 2- 20 ,(1993) , 10.1177/002199839302700101
A.J. Barker, V. Balasundaram, Compression testing of carbon fibre-reinforced plastics exposed to humid environments Composites. ,vol. 18, pp. 217- 226 ,(1987) , 10.1016/0010-4361(87)90411-3