Pressure response and life assessment of filament-wound composite pipes after impact
作者： William Harris , Constantinos Soutis , Matthieu Gresil , Christopher Atkin
DOI: 10.1016/J.IJLMM.2020.06.002
关键词:
摘要: Abstract This paper presents the results of drop-weight impact (5 J–150 J), quasi-static indentation, and post-impact internal pressure testing a ±55°, filament-wound, glass fibre reinforced epoxy (GRE) pipe. The void content in tested pipes was quantified by optical stereo microscopy image analysis ranged from 5% to approximately 13%. found not influence damage area, or observed mechanisms, following loading. However, greatly affect tolerance pipe during an impact. It is established that area alone enough determine reduction failure performance under pressure. After impacts at low energies, number surpassed operating pressurisation (no leakage occurred). In these instances, industry accepted regression gradient used pipe's residual life, which estimated service life 20 years less than two years. indentation confirmed energy behaviour (
sci-hub.st 参考文章(19)
GAO Davies, R Olsson, Impact on Composite Structures ,(1998)
Uday K. Vaidya, Impact Response of Laminated and Sandwich Composites Springer Vienna. pp. 97- 191 ,(2011) , 10.1007/978-3-7091-0523-8_4
A Hawa, MS Abdul Majid, M Afendi, HFA Marzuki, NAM Amin, F Mat, AG Gibson, None, Burst strength and impact behaviour of hydrothermally aged glass fibre/epoxy composite pipes Materials & Design. ,vol. 89, pp. 455- 464 ,(2016) , 10.1016/J.MATDES.2015.09.082
G.A. Schoeppner, S. Abrate, Delamination threshold loads for low velocity impact on composite laminates Composites Part A-applied Science and Manufacturing. ,vol. 31, pp. 903- 915 ,(2000) , 10.1016/S1359-835X(00)00061-0
C. Soutis, Fibre reinforced composites in aircraft construction Progress in Aerospace Sciences. ,vol. 41, pp. 143- 151 ,(2005) , 10.1016/J.PAEROSCI.2005.02.004
Y. Shi, T. Swait, C. Soutis, Modelling damage evolution in composite laminates subjected to low velocity impact Composite Structures. ,vol. 94, pp. 2902- 2913 ,(2012) , 10.1016/J.COMPSTRUCT.2012.03.039
J. Lee, C. Soutis, Prediction of impact-induced fibre damage in circular composite plates Applied Composite Materials. ,vol. 12, pp. 109- 131 ,(2005) , 10.1007/S10443-004-7767-8
Memduh Kara, Mesut Uyaner, Ahmet Avci, Ahmet Akdemir, Effect of non-penetrating impact damages of pre-stressed GRP tubes at low velocities on the burst strength Composites Part B-engineering. ,vol. 60, pp. 507- 514 ,(2014) , 10.1016/J.COMPOSITESB.2014.01.003
J Curtis, M.J Hinton, S Li, S.R Reid, P.D Soden, Damage, deformation and residual burst strength of filament-wound composite tubes subjected to impact or quasi-static indentation Composites Part B-engineering. ,vol. 31, pp. 419- 433 ,(2000) , 10.1016/S1359-8368(00)00014-7
Mehmet Emin Deniz, Ramazan Karakuzu, Seawater effect on impact behavior of glass–epoxy composite pipes Composites Part B-engineering. ,vol. 43, pp. 1130- 1138 ,(2012) , 10.1016/J.COMPOSITESB.2011.11.006