Competition behavior of the strengthening effects in as-extruded AZ91 matrix: Influence of pre-existed Mg17Al12 phase
作者： Cui-ju Wang , Kun-kun Deng , Kai-bo Nie , Shuan-jun Shang , Wei Liang
DOI: 10.1016/J.MSEA.2016.01.023
关键词:
摘要: Abstract The AZ91 alloy containing (“AC”) and without (“AS”) Mg 17 Al 12 phase were both subject to hot extrusion at 693 K with the ratio of 16:1. Results showed that pre-existed in “AC” led finer grain size lower intensity basal plane texture as compared “AS” alloy. Almost same YS between indicated boundary precipitation strengthening was balanced by solid solution Nevertheless, elongated along direction reduced its ultimate tensile strength Existence SiCp a dispersive uniform distribution phase, which gave full play on composite. Unlike alloy, just composite contributed higher UTS
sci-hub.se 参考文章(27)
Hui–Yuan Wang, En–Bo Zhang, Xiao–Long Nan, Lei Zhang, Zhi–Ping Guan, Qi–Chuan Jiang, A comparison of microstructure and mechanical properties of Mg–9Al–1Zn sheets rolled from as-cast, cast-rolling and as-extruded alloys Materials & Design. ,vol. 89, pp. 167- 172 ,(2016) , 10.1016/J.MATDES.2015.09.107
X. Li, F. Jiao, T. Al-Samman, S. Ghosh Chowdhury, Influence of second-phase precipitates on the texture evolution of Mg–Al–Zn alloys during hot deformation Scripta Materialia. ,vol. 66, pp. 159- 162 ,(2012) , 10.1016/J.SCRIPTAMAT.2011.10.028
A. Mussi, J.J. Blandin, L. Salvo, E.F. Rauch, Resistance to strain-induced damage of an ultrafine-grained magnesium alloy deformed in superplastic conditions Acta Materialia. ,vol. 54, pp. 3801- 3809 ,(2006) , 10.1016/J.ACTAMAT.2006.04.011
R.D. Doherty, D.A. Hughes, F.J. Humphreys, J.J. Jonas, D.Juul Jensen, M.E. Kassner, W.E. King, T.R. McNelley, H.J. McQueen, A.D. Rollett, Current issues in recrystallization: a review Materials Science and Engineering: A. ,vol. 238, pp. 219- 274 ,(1997) , 10.1016/S0921-5093(97)00424-3
Zhifeng Li, Jie Dong, Xiao Qing Zeng, Chen Lu, Weng Jiang Ding, Influence of Mg17Al12 intermetallic compounds on the hot extruded microstructures and mechanical properties of Mg–9Al–1Zn alloy Materials Science and Engineering A-structural Materials Properties Microstructure and Processing. ,vol. 466, pp. 134- 139 ,(2007) , 10.1016/J.MSEA.2007.02.029
S.W. Xu, N. Matsumoto, S. Kamado, T. Honma, Y. Kojima, Effect of Mg17Al12 precipitates on the microstructural changes and mechanical properties of hot compressed AZ91 magnesium alloy Materials Science and Engineering: A. ,vol. 523, pp. 47- 52 ,(2009) , 10.1016/J.MSEA.2009.05.032
S.W. Xu, K. Oh-ishi, H. Sunohara, S. Kamado, Extruded Mg–Zn–Ca–Mn alloys with low yield anisotropy Materials Science and Engineering: A. ,vol. 558, pp. 356- 365 ,(2012) , 10.1016/J.MSEA.2012.08.012
H Friedrich, S Schumann, Research for a new age of magnesium in the automotive industry Journal of Materials Processing Technology. ,vol. 117, pp. 276- 281 ,(2001) , 10.1016/S0924-0136(01)00780-4
Weiqin Tang, Shiyao Huang, Shaorui Zhang, Dayong Li, Yinghong Peng, Influence of extrusion parameters on grain size and texture distributions of AZ31 alloy Journal of Materials Processing Technology. ,vol. 211, pp. 1203- 1209 ,(2011) , 10.1016/J.JMATPROTEC.2011.01.014
S.W. Xu, S. Kamado, T. Honma, Effect of homogenization on microstructures and mechanical properties of hot compressed Mg–9Al–1Zn alloy Materials Science and Engineering A-structural Materials Properties Microstructure and Processing. ,vol. 528, pp. 2385- 2393 ,(2011) , 10.1016/J.MSEA.2010.11.047