Press fit passive component
作者： Gary D Frasco
DOI:
关键词:
摘要: A press fit passive component, such as a resistor or capacitor, adapted to within, partially via of printed circuit board. In one example, the component has cylindrically shaped body with solderable terminals at either end body, and dielectric collar disposed least about body.
lens.org 参考文章(25)
Zsolt G. Takacs, Peter Liao, Termination board for mounting on circuit board ,(2000)
Bruce Ray Lane, Circuit board configuration ,(2008)
William Rugg, In-line electrical connector ,(1996)
Hirofumi A Intellect. Property Dept. Sunahara, Multi-layer ceramic substrate and method for producing the same ,(1998)
Michael C. Cilia, Gurpreet S. Dayal, Don Nguyen, Arthur K. May, Apparatus and method for removing a soldered device from a printed circuit board ,(2001)
Louis A. Abbagnaro, William J. Siegel, William J. Kantter, Printed circuit thermocouple arrangements for personnel training and equipment evaluation purposes ,(1992)
Teruhisa Hayashi, Kouki Ogawa, Yasutake Hotta, Printed wiring substrate and method for fabricating the same ,(2001)
Yujian You, Michael K. Gallagher, Electronic device manufacture ,(2001)
Tom Sahakian, James J. Levante, Dennis Johnson, Conductive elastomeric and mechanical pin and contact system ,(2009)