On the Optimization of the Fiber Reinforced Composites Manufacturing Process with Two Pressure Steps
作者： V. Dementyev , S. Kostritskiy , M. Petuhov , A. Torkunov
DOI: 10.1007/978-94-011-2874-2_3
关键词:
摘要: In this paper the mechanical model describing fiber reinforced composites manufacturing process is considered. It required that optimal resin fraction should be reached at end of process. An algorithm definition corresponding parameters for two-step press processing presented. Numerical results are obtained homogeneous and inhomogeneous temperature distributions in laminate package.
springer.com
sci-hub.st 参考文章(5)
Jian-Mao Tang, Woo I. Lee, George S. Springer, Effects of Cure Pressure on Resin Flow, Voids, and Mechanical Properties Journal of Composite Materials. ,vol. 21, pp. 421- 440 ,(1987) , 10.1177/002199838702100502
Timothy G. Gutowski, Tadahiko Morigaki, Zhong Cai, The Consolidation of Laminate Composites Journal of Composite Materials. ,vol. 21, pp. 172- 188 ,(1987) , 10.1177/002199838702100207
Alfred C. Loos, George S. Springer, Curing of Epoxy Matrix Composites Journal of Composite Materials. ,vol. 17, pp. 135- 169 ,(1983) , 10.1177/002199838301700204
D.Y. Paithankar, A.S. Sangani, G.C. Martin, Effect of Nonuniformities in Temperature on Resin Flow during the Lamination of Polymer Composites Journal of Composite Materials. ,vol. 24, pp. 309- 325 ,(1990) , 10.1177/002199839002400305
Mark R. Dusi, Woo I. Lee, Peter R. Ciriscioli, George S. Springer, Cure Kinetics and Viscosity of Fiberite 976 Resin Journal of Composite Materials. ,vol. 21, pp. 243- 261 ,(1987) , 10.1177/002199838702100304