Composites made from CF prepreg trim waste tapes using sheet molding compounds (SMC) technology: Challenges and potential
作者： Sanzida Sultana , Amir Asadi , Jonathan Colton , Kyriaki Kalaitzidou
DOI: 10.1016/J.COMPOSITESA.2020.105906
关键词:
摘要: Abstract This study explores the use of carbon fiber (CF) prepreg trim waste to manufacture lightweight, high performance and low cost CF composites using sheet molding compound (SMC) technology. First, modifications a typical SMC flow determine charge in size mass sheets are determined. Then, effect age tapes, aspect ratio cut chips pressure during compression on tensile impact properties is determined these compares with those composites. It concluded that (i) standard production line needs be modified order successfully convert tapes into (ii) produced can meet stiffness acceptable strength for not strength-critical applications without need store controlled conditions.
sci-hub.se 参考文章(13)
P. K. Mallick, Fiber-reinforced composites : materials, manufacturing, and design M. Dekker. ,(2008)
J.C. Halpin, Stiffness and Expansion Estimates for Oriented Short Fiber Composites Journal of Composite Materials. ,vol. 3, pp. 732- 734 ,(1969) , 10.1177/002199836900300419
Yingfeng Yu, Huihuang Su, Wenjun Gan, Effects of Storage Aging on the Properties of Epoxy Prepregs Industrial & Engineering Chemistry Research. ,vol. 48, pp. 4340- 4345 ,(2009) , 10.1021/IE8018005
Haijun Cai, M.T. Bashar, J.J.C. Picot, Thermal and mechanical anisotropy in compression molded carbon fiber/resin composites† Polymer Composites. ,vol. 26, pp. 684- 688 ,(2005) , 10.1002/PC.20138
A.J Shields, D.M Hepburn, I.J Kemp, J.M Cooper, The absorption of mould release agent by epoxy resin Polymer Degradation and Stability. ,vol. 70, pp. 253- 258 ,(2000) , 10.1016/S0141-3910(00)00121-X
K. Lu, The Future of Metals Science. ,vol. 328, pp. 319- 320 ,(2010) , 10.1126/SCIENCE.1185866
J. C. Halpin, J. L. Karoos, Strength of discontinuous reinforced composites: I. Fiber reinforced composites Polymer Engineering and Science. ,vol. 18, pp. 496- 504 ,(1978) , 10.1002/PEN.760180612
Paolo Feraboli, Tyler Cleveland, Patrick Stickler, John Halpin, Stochastic laminate analogy for simulating the variability in modulus of discontinuous composite materials Composites Part A-applied Science and Manufacturing. ,vol. 41, pp. 557- 570 ,(2010) , 10.1016/J.COMPOSITESA.2010.01.003
Mohammad Hossein Habibi, Effects of out-time on cure kinetics and rheological properties of out-of-autoclave and autoclave prepregs Wichita State University. ,(2013)
A.D. Evans, C.C. Qian, T.A. Turner, L.T. Harper, N.A. Warrior, Flow characteristics of carbon fibre moulding compounds Composites Part A-applied Science and Manufacturing. ,vol. 90, pp. 1- 12 ,(2016) , 10.1016/J.COMPOSITESA.2016.06.020