Machining of LM13 and LM28 cast aluminium alloys: Part I
作者： D.K. Dwivedi , A. Sharma , T.V. Rajan
DOI: 10.1016/J.JMATPROTEC.2007.05.032
关键词:
摘要: Abstract In present paper, the influence of melt treatment (grain refinement and modification) heat (T6) cast LM13 LM28 aluminium alloys on machining behaviour has been reported. Alloys under investigation were prepared by controlled melting casting followed (T6). As-cast, melt-treated heat-treated investigated for characteristic at different cutting speeds. Melt both (LM13 LM28) reduced force temperature whereas increased temperature. Cutting was found higher in alloy than alloy. Maximum conditions. Heat surface roughness it. average number chips per gm. produced gm
elsevier.com
sci-hub.se 参考文章(3)
Dheerendra Kumar Dwivedi, A. Sharma, T. V. Rajan, Influence of Silicon Morphology and Mechanical Properties of Piston Alloys Materials and Manufacturing Processes. ,vol. 20, pp. 777- 791 ,(2005) , 10.1081/AMP-200055138
A.A.O. Tay, K.H. Lee, Calculation of temperature distributions in machining using a hybrid finite-element-boundary-element method Journal of Materials Processing Technology. ,vol. 29, pp. 47- 62 ,(1992) , 10.1016/0924-0136(92)90424-Q
L. Wang, M. Makhlouf, D. Apelian, Aluminium die casting alloys: alloy composition, microstructure, and properties-performance relationships International Materials Reviews. ,vol. 40, pp. 221- 238 ,(1995) , 10.1179/IMR.1995.40.6.221