Experimental optimization of ion wind generator with needle to parallel plates for cooling device

作者: Dong Ho Shin , Joon Shik Yoon , Han Seo Ko

DOI: 10.1016/J.IJHEATMASSTRANSFER.2015.01.018

关键词:

摘要: Abstract An efficient cooling system is needed for Light Emitting Diode (LED) devices since they consume 70% of the applied power as heat. Thus, much research on has been performed this century. However, most developed systems do not have high enough efficiency, and are accompanied with other demerits such noise, weight, size problems. Therefore, an ion wind generator was suggested use a new device in study. The characteristics from needle to parallel plate electrodes were analyzed developing optimized devices. Temperature changes induced by measured under various conditions quantitative analysis. performance confirmed experimental numerical results. Finally, optimization accomplished.

参考文章(24)
B. L. Owsenek, J. Seyed-Yagoobi, R. H. Page, Experimental Investigation of Corona Wind Heat Transfer Enhancement With a Heated Horizontal Flat Plate Journal of Heat Transfer-transactions of The Asme. ,vol. 117, pp. 309- 315 ,(1995) , 10.1115/1.2822522
Daeseok Jang, Seung-Hwan Yu, Kwan-Soo Lee, Multidisciplinary optimization of a pin-fin radial heat sink for LED lighting applications International Journal of Heat and Mass Transfer. ,vol. 55, pp. 515- 521 ,(2012) , 10.1016/J.IJHEATMASSTRANSFER.2011.11.016
Y. Zebboudj, R. Ikene, Positive corona inception in HVDC configurations under variable air density and humidity conditions European Physical Journal-applied Physics. ,vol. 10, pp. 211- 218 ,(2000) , 10.1051/EPJAP:2000134
Daeseok Jang, Seung-Jae Park, Se-Jin Yook, Kwan-Soo Lee, The orientation effect for cylindrical heat sinks with application to LED light bulbs International Journal of Heat and Mass Transfer. ,vol. 71, pp. 496- 502 ,(2014) , 10.1016/J.IJHEATMASSTRANSFER.2013.12.037
A. P. Chattock, XLIV. On the velocity and mass of the ions in the electric wind in air Philosophical Magazine Series 1. ,vol. 48, pp. 401- 420 ,(1899) , 10.1080/14786449908621431
Ing Youn Chen, Mei-Zuo Guo, Kai-Shing Yang, Chi-Chuan Wang, Enhanced cooling for LED lighting using ionic wind International Journal of Heat and Mass Transfer. ,vol. 57, pp. 285- 291 ,(2013) , 10.1016/J.IJHEATMASSTRANSFER.2012.10.015
Hsiu-Che Wang, Nels E. Jewell-Larsen, Alexander V. Mamishev, Thermal management of microelectronics with electrostatic fluid accelerators Applied Thermal Engineering. ,vol. 51, pp. 190- 211 ,(2013) , 10.1016/J.APPLTHERMALENG.2012.08.068
N. Kasayapanand, Electrohydrodynamic enhancement of heat transfer in vertical fin array using computational fluid dynamics technique International Communications in Heat and Mass Transfer. ,vol. 35, pp. 762- 770 ,(2008) , 10.1016/J.ICHEATMASSTRANSFER.2008.02.008
Myron Robinson, Movement of air in the electric wind of the corona discharge Transactions of the American Institute of Electrical Engineers, Part I: Communication and Electronics. ,vol. 80, pp. 143- 150 ,(1961) , 10.1109/TCE.1961.6373091
B. L. Owsenek, J. Seyed-Yagoobi, Theoretical and Experimental Study of Electrohydrodynamic Heat Transfer Enhancement Through Wire-Plate Corona Discharge Journal of Heat Transfer-transactions of The Asme. ,vol. 119, pp. 604- 610 ,(1997) , 10.1115/1.2824148