On Constitutive Relations and Failure Criteria of an Austenitic Steel under Cyclic Loading at Elevated Temperature
作者： I. W. Goodall , R. Hales , D. J. Walters
DOI: 10.1007/978-3-642-81598-0_6
关键词:
摘要: The paper records and interprets a series of tests on 316 stainless steel at 600°C which seek to investigate the interaction short term plastic deformation subsequent creep deformation. Strain controlled have been used determine influence strain range, number cycles dwell period. implications for structural behaviour prediction stress relaxation are discussed.
springer.com
sci-hub.st 参考文章(11)
Z. Mr�z, N. C. Lind, Simplified theories of cyclic plasticity Acta Mechanica. ,vol. 22, pp. 131- 152 ,(1975) , 10.1007/BF01170622
P.J. Goodhew, R.M. Allen, Comments on: “Low energy grain boundaries in metals” by Herrmann, Gleiter and Ba̋ro, Acta Met Scripta Metallurgica. ,vol. 11, pp. 37- 39 ,(1977) , 10.1016/0036-9748(77)90009-6
F.A. Leckie, D.R. Hayhurst, Constitutive equations for creep rupture Acta Metallurgica. ,vol. 25, pp. 1059- 1070 ,(1977) , 10.1016/0001-6160(77)90135-3
M. Chrzanowski, Use of the damage concept in describing creep-fatigue interaction under prescribed stress International Journal of Mechanical Sciences. ,vol. 18, pp. 69- 73 ,(1976) , 10.1016/0020-7403(76)90053-9
R.A. Ainsworth, A note on bounding solutions for creeping structures subjected to load variations above the shakedown limit International Journal of Solids and Structures. ,vol. 15, pp. 981- 986 ,(1979) , 10.1016/0020-7683(79)90026-X
C. O. Frederick, P. J. Armstrong, Convergent internal stresses and steady cyclic states of stress Journal of Strain Analysis for Engineering Design. ,vol. 1, pp. 154- 159 ,(1966) , 10.1243/03093247V012154
B. K. Min, R. Raj, The Importance of Wedge Cracking in Creep Fatigue Canadian Metallurgical Quarterly. ,vol. 18, pp. 171- 176 ,(1979) , 10.1179/CMQ.1979.18.2.171
B. F. Dyson, D. Mclean, Creep of Nimonic 80A in torsion and tension Metal science. ,vol. 11, pp. 37- 45 ,(1977) , 10.1179/MSC.1977.11.2.37
K. A. Afimiwala, R. W. Mayne, A Contour Plotting Scheme for Design Optimization Journal of Mechanical Design. ,vol. 101, pp. 349- 354 ,(1979) , 10.1115/1.3454061
B. Tomkins, Fatigue crack propagation—an analysis Philosophical Magazine. ,vol. 18, pp. 1041- 1066 ,(1968) , 10.1080/14786436808227524