Effect of uncut chip thickness on the ploughing force in orthogonal cutting
作者： Alexey Popov , Andrey Dugin , None
DOI: 10.1007/S00170-014-6423-1
关键词:
摘要: Determination of the ploughing forces is necessary for monitoring wear cutting tool in micro cutting. The aim this research was to increase accuracy determining force and determination influence uncut chip thickness on force. A new method suggested article. It found that determined by were greater than those comparing total at different flank levels wear. first established influences
springer.com
sci-hub.se 参考文章(20)
Nikolai Nikolaevich Zorev, Metal cutting mechanics Pergamon. ,(1966)
P. Albrecht, New Developments in the Theory of the Metal-Cutting Process: Part I. The Ploughing Process in Metal Cutting Journal of Engineering for Industry. ,vol. 82, pp. 348- 357 ,(1960) , 10.1115/1.3664242
I.N Tansel, T.T Arkan, W.Y Bao, N Mahendrakar, B Shisler, D Smith, M McCool, Tool wear estimation in micro-machining. International Journal of Machine Tools and Manufacture. ,vol. 40, pp. 599- 608 ,(2000) , 10.1016/S0890-6955(99)00073-5
K. Jemielniak, S. Bombiński, P.X. Aristimuno, Tool condition monitoring in micromilling based on hierarchical integration of signal measures CIRP Annals. ,vol. 57, pp. 121- 124 ,(2008) , 10.1016/J.CIRP.2008.03.053
Y.B. Guo, Y.K. Chou, The determination of ploughing force and its influence on material properties in metal cutting Journal of Materials Processing Technology. ,vol. 148, pp. 368- 375 ,(2004) , 10.1016/J.JMATPROTEC.2004.02.052
Robin Stevenson, The measurement of parasitic forces in orthogonal cutting International Journal of Machine Tools & Manufacture. ,vol. 38, pp. 113- 130 ,(1998) , 10.1016/S0890-6955(97)00022-9
A. V. Popov, A. V. Dugin, Experimental methods of determining the cutting forces at the tool’s rear surface Russian Engineering Research. ,vol. 32, pp. 68- 69 ,(2012) , 10.3103/S1068798X12010248
Alexey Popov, Andrey Dugin, None, A comparison of experimental estimation methods of the ploughing force in orthogonal cutting International Journal of Machine Tools & Manufacture. ,vol. 65, pp. 37- 40 ,(2013) , 10.1016/J.IJMACHTOOLS.2012.09.003
Robin Stevenson, David A. Stephenson, The mechanical behavior of zinc during machining Journal of Engineering Materials and Technology-transactions of The Asme. ,vol. 117, pp. 172- 178 ,(1995) , 10.1115/1.2804526
S.M. Afazov, D. Zdebski, S.M. Ratchev, J. Segal, S. Liu, Effects of micro-milling conditions on the cutting forces and process stability Journal of Materials Processing Technology. ,vol. 213, pp. 671- 684 ,(2013) , 10.1016/J.JMATPROTEC.2012.12.001