On-line evaluation of the stability of an inspection process
作者： Ismael Sánchez , Isabel González
DOI: 10.1002/ASMB.V25:6
关键词:
摘要: This article proposes control charts to monitor an inspection process based on the defective proportion of inspected parts. The focus is where incoming parts form a sequence independent units, such as unrelated clients arriving at service facility. An example this kind periodic motor vehicle (PMVI) inspection. effectiveness proposed evaluated using Monte Carlo experiments and applied actual PMVI station. Copyright © 2009 John Wiley & Sons, Ltd.
sci-hub.st 参考文章(16)
Kenneth W. Linna, William H. Woodall, Effect of Measurement Error on Shewhart Control Charts Journal of Quality Technology. ,vol. 33, pp. 213- 222 ,(2001) , 10.1080/00224065.2001.11980068
Anthony J. Hayter, Kwok-Leung Tsui, Identification and Quantification in Multivariate Quality Control Problems Journal of Quality Technology. ,vol. 26, pp. 197- 208 ,(1994) , 10.1080/00224065.1994.11979526
Thomas P. Ryan, Neil C. Schwertman, OPTIMAL LIMITS FOR ATTRIBUTES CONTROL CHARTS Journal of Quality Technology. ,vol. 29, pp. 86- 98 ,(1997) , 10.1080/00224065.1997.11979728
Marion R. Reynolds, Zachary G. Stoumbos, A CUSUM Chart for Monitoring a Proportion When Inspecting Continuously Journal of Quality Technology. ,vol. 31, pp. 87- 108 ,(1999) , 10.1080/00224065.1999.11979900
Richard K. Burdick, Greg A. Larsen, Confidence Intervals on Measures of Variability in R&R Studies Journal of Quality Technology. ,vol. 29, pp. 261- 273 ,(1997) , 10.1080/00224065.1997.11979768
Alan Winterbottom, Simple adjustments to improve control limits on attribute charts Quality and Reliability Engineering International. ,vol. 9, pp. 105- 109 ,(1993) , 10.1002/QRE.4680090207
Douglas C Montgomery, George C Runger, None, GAUGE CAPABILITY AND DESIGNED EXPERIMENTS. PART I: BASIC METHODS Quality Engineering. ,vol. 6, pp. 115- 135 ,(1993) , 10.1080/08982119308918710
RASUL A. KHAN, A note on Page's two-sided cumulative sum procedure Biometrika. ,vol. 68, pp. 717- 719 ,(1981) , 10.1093/BIOMET/68.3.717
Russell A Boyles, Gauge Capability for Pass—Fail Inspection Technometrics. ,vol. 43, pp. 223- 229 ,(2001) , 10.1198/004017001750386332
Hans-Joachim Mittag, Dietmar Stemann, Gauge imprecision effect on the performance of the X-S control chart Journal of Applied Statistics. ,vol. 25, pp. 307- 317 ,(1998) , 10.1080/02664769823043