Encapsulated MOV surge arrester for with standing over 100,000 amps of surge per doc
作者： Jr. Roy Benson Carpenter
DOI:
关键词:
摘要: An improved apparatus and method for encapsulating a single large MOV is shown. The sandwiched between aluminum contact plates. epoxy fills the void space A dielectric film encapsulates entire sandwich. Soft films of foil or deposition coating used to cover surface cure facial defects. optional exterior case protects assemblies contained therein from short circuits due dirt, grease water build-up. designed withstand over 100,000 amps surge in commercial up 220 volt per phase secondary power system.
lens.org 参考文章(12)
Gary L. Goedde, Robert N. Schettler, Stanley S. Kershaw, Low voltage, high energy surge arrester for secondary applications ,(1990)
Gary H. Wiseman, Ronald J. Mosso, Jeffrey A. Bennett, William M. Robinson, John T. Fossett, Electrical surge arrester ,(1993)
Harry George Yaworski, Larry Norman Siebens, Surge arrester with rigid insulating housing ,(1990)
Jr. Roy B. Carpenter, Parallel MOV surge arrester ,(1994)
L. William Menzies, Stephen W. Menzies, Surface mounted decoupling capacitor ,(1989)
Gary H. Wiseman, Edward S. Sherman, Mark S. Thompson, Metal oxide varistors, precursor powder compositions and methods for preparing same ,(1987)
Norbert Mikli, Electrical protection apparatus ,(1991)
Stephen F. Larson, Robert D. Rozanski, James Roger Medlock, Uniform current and voltage distribution device ,(1990)
Udo Eberhard Koch, Bodo Boettcher, Packing arrangement, particularly a surge arrester ,(1986)
Bodo Boettcher, Paul Dr. Tamplin, Udo Eberhard Koch, Frangible housing for an electrical component ,(1986)