Characteristics of ash formation in the process of combustion of pelletised leather tannery waste and hardwood pellets
作者： Jacek Kluska , Tomasz Turzyński , Mateusz Ochnio , Dariusz Kardaś
DOI: 10.1016/J.RENENE.2019.10.122
关键词:
摘要: Abstract This paper presents a characterisation of the combustion mixtures pelletised leather tannery waste (LTW) and hardwood pellets (HP) on grate. The experimental investigation was carried out in laboratory-scale reactor with use thermogravimetric analysis (TGA). Proximate ultimate showed that may constitute promising fuel, relatively high heating value at level 16 MJ/kg. highest thermal degradation reached 326 °C; characteristics are include by two peaks corresponding to 406 432 °C. results process doping does not significantly affect temperatures fuel bed perforated flat gate test reactor. Furthermore, ash content affects formation layer, which increases along increased contents waste.
sci-hub.se 参考文章(34)
Jaap Koppejan, Sjaak Van Loo, None, The Handbook of Biomass Combustion and Co-firing Routledge. ,(2012) , 10.4324/9781849773041
A John Chandler, T Taylor Eighmy, O Hjelmar, DS Kosson, SE Sawell, J Vehlow, HA Van der Sloot, J Hartlén, Municipal Solid Waste Incinerator Residues ,(1997)
E. Bañón, A. Marcilla, A.N. García, P. Martínez, M. León, Kinetic model of the thermal pyrolysis of chrome tanned leather treated with NaOH under different conditions using thermogravimetric analysis. Waste Management. ,vol. 48, pp. 285- 299 ,(2016) , 10.1016/J.WASMAN.2015.10.012
François-Xavier Collard, Joël Blin, A review on pyrolysis of biomass constituents: Mechanisms and composition of the products obtained from the conversion of cellulose, hemicelluloses and lignin Renewable and Sustainable Energy Reviews. ,vol. 38, pp. 594- 608 ,(2014) , 10.1016/J.RSER.2014.06.013
Zheng Li, Denis Paudecerf, Jiashi Yang, None, Mechanical behaviour of natural cow leather in tension Acta Mechanica Solida Sinica. ,vol. 22, pp. 37- 44 ,(2009) , 10.1016/S0894-9166(09)60088-4
Robert Bauer, Markus Gölles, Thomas Brunner, Nicolaos Dourdoumas, Ingwald Obernberger, Modelling of grate combustion in a medium scale biomass furnace for control purposes Biomass & Bioenergy. ,vol. 34, pp. 417- 427 ,(2010) , 10.1016/J.BIOMBIOE.2009.12.005
Arkadiusz Ryfa, Rafal Buczynski, Michal Chabinski, Andrzej Szlek, Ryszard A. Bialecki, Decoupled numerical simulation of a solid fuel fired retort boiler Applied Thermal Engineering. ,vol. 73, pp. 794- 804 ,(2014) , 10.1016/J.APPLTHERMALENG.2014.08.029
Yu Wang, Yixin Shao, Miodrag Darko Matovic, Joann K. Whalen, Exploring switchgrass and hardwood combustion on excess air and ash fouling/slagging potential: Laboratory combustion test and thermogravimetric kinetic analysis Energy Conversion and Management. ,vol. 97, pp. 409- 419 ,(2015) , 10.1016/J.ENCONMAN.2015.03.070
Maider Amutio, Gartzen Lopez, Roberto Aguado, Maite Artetxe, Javier Bilbao, Martin Olazar, Kinetic study of lignocellulosic biomass oxidative pyrolysis Fuel. ,vol. 95, pp. 305- 311 ,(2012) , 10.1016/J.FUEL.2011.10.008
M.J. Fernández Llorente, J.E. Carrasco García, Comparing methods for predicting the sintering of biomass ash in combustion Fuel. ,vol. 84, pp. 1893- 1900 ,(2005) , 10.1016/J.FUEL.2005.04.010