Comparison of two- and three-body wear of glass-ionomers and composites.

作者: Matthias Pelka , Johannes Ebert , Harald Schneider , Norbert Kramer , Anselm Petschelt

DOI: 10.1111/J.1600-0722.1996.TB00057.X

关键词:

摘要: The two-body and three-body wear of glass-ionomers (GIC), visible light cured (VLC-GIC), composites were compared. simulations performed for the in an artificial mouth with so-called ACTA machine. tested materials different conventional glass-ionomers, composites, amalgam. rates 8 specimens each material 16 test After 10(5) cycles testing device, shapes measured. All measurements related to rate For method, worn qualitatively judged by scanning electron microscopy. two methods lead similar results slight differences ranking. Amalgam showed lowest both methods. Photac Fil, a newly developed VLC-GIC, dramatically lower resistance than GIC Further investigations are necessary identify material-specific parameters influencing behaviour relation

参考文章(6)
P. Pallav, A.J. De Gee, C.L. Davidson, R.L. Erickson, E.A. Glasspoole, The Influence of Admixing Microfiller to Small-particle Composite Resin on Wear, Tensile Strength, Hardness, and Surface Roughness Journal of Dental Research. ,vol. 68, pp. 489- 490 ,(1989) , 10.1177/00220345890680031101
Prem Pallav, Carel L. Davidson, Anton J. de Gee, Wear rates of composites, an amalgam, and enamel under stress-bearing conditions Journal of Prosthetic Dentistry. ,vol. 59, pp. 426- 429 ,(1988) , 10.1016/0022-3913(88)90036-4
A.J. Degee, P. Pallav, C.L. Davidson, Effect of Abrasion Medium on Wear of Stress-bearing Composites and Amalgam in vitro Journal of Dental Research. ,vol. 65, pp. 654- 658 ,(1986) , 10.1177/00220345860650050401
A.J. de Gee, P. Pallav, Occlusal wear simulation with the ACTA wear machine. Journal of Dentistry. ,vol. 22, ,(1994) , 10.1016/0300-5712(94)90167-8
R.W. Wassell, J.E. McCabe, A.W.G. Walls, A Two-body Frictional Wear Test Journal of Dental Research. ,vol. 73, pp. 1546- 1553 ,(1994) , 10.1177/00220345940730091001