Diffusion bonding of the high temperature Ti alloy IMI 829 to Fe-Ni alloy IN 907 using interlayers
作者： A. Wisbey , C.M. Ward-Close
DOI: 10.1016/0167-577X(94)90122-8
关键词:
摘要: Abstract There is considerable interest in the use of titanium alloys place steels and nickel alloys, however, poor tribological properties have mitigated against its widespread use. Wear resistant surfaces an iron-nickel alloy IN 907 been diffusion bonded to high temperature IMI 829, using interlayers aid bonding. High shear strength joints produced. A combination Ta Ni has found be particularly advantageous, increasing both plastic deformation fracture.
elsevier.com
sci-hub.se 参考文章(6)
O. M. Akselsen, Diffusion bonding of ceramics Journal of Materials Science. ,vol. 27, pp. 569- 579 ,(1992) , 10.1007/BF02403862
Kenneth G. Budinski, Tribological properties of titanium alloys Wear. ,vol. 151, pp. 203- 217 ,(1991) , 10.1016/0043-1648(91)90249-T
P. G. Partridge, D. V. Dunford, On the testing of diffusion-bonded overlap joints between clad Al-Zn-Mg alloy(7010) sheet Journal of Materials Science. ,vol. 22, pp. 1597- 1608 ,(1987) , 10.1007/BF01132379
S. Hinotani, Y. Ohmori, The Microstructure of Diffusion-bonded Ti/Ni Interface Materials Transactions Jim. ,vol. 29, pp. 116- 124 ,(1988) , 10.2320/MATERTRANS1960.29.116
B. Alemán, L. Gutiérrez, J. J. Urcola, Interface microstructures in diffusion bonding of titanium alloys to stainless and low alloy steels Materials Science and Technology. ,vol. 9, pp. 633- 641 ,(1993) , 10.1179/MST.1993.9.8.633
Thaddeus B Massalski, Hiroaki Okamoto, PRnbsp Subramanian, Linda Kacprzak, William W Scott, None, Binary alloy phase diagrams ASM International. ,vol. 3, pp. 2874- ,(1986)