Temperature control in an ebullated bed reactor
作者： Scott M. Sayles , Michael P. Bellinger , William B. Livingston
DOI:
关键词:
摘要: A method has been discovered for controlling catalytic reactor bed temperature in an ebullated process. sour, aromatic feedstock is mixed with a conventional residual oil controlled ratio. The catalytically cracked and thereby releases heat. flow rate of the to maintain at selected reaction temperature. Both feedstocks are upgraded fuel boiling range fraction fired heater eliminated optionally hydrogen-containing gas feed stream as well.
lens.org 参考文章(10)
Michael C Chervenak, Seymour B Alpert, Ronald H Wolk, High conversion hydrogenation ,(1967)
Lawrence B. Peck, Robert D. Buttke, Jeffry A. Cox, George L. Ott, Process for reducing resid hydrotreating solids in a fractionator ,(1987)
Norman K. Mcdaniel, Robert E. Boening, Norman R. Woods, Nicholas C. Vasti, Resid hydrotreating with high temperature flash drum recycle oil ,(1988)
Lawrence M. Abrams, Quenching hydrocarbon effluent from catalytic reactor to avoid precipitation of asphaltene compounds ,(1982)
E Layng, Hydrogenation of tar sand bitumen ,(1972)
William R Mounce, Roger P Van Driesen, Residual oil hydrogen treating process ,(1970)
M Chervenak, R Wolk, Treating tar sands bitumen ,(1972)
James W. Hobbs, David A. Christie, Automatic control of a hydrocracker ,(1975)
Paul H. Kydd, Phase separation of hydrocarbon liquids using liquid vortex ,(1981)
L Champion, W Hopkins, W White, Means and method for automatically controlling the hydrogen to hydrocarbon mole ratio during the conversion of a hydrocarbon ,(1972)