Method for overmolding sink marks for an automotive component
作者： Marshall Ray Porter
DOI:
关键词:
摘要: A method, molding device and vehicle component (10) provide for minimized sink marks (30) caused by structural ribs (28) in the process. Molten material is injected into a first mold cavity to form primary part (20) having on back side. Typically, may develop at front surface of (20), located opposite second that arranged overmold (26) cover (30), if any, (26). In this manner, manufactured with without visible (30).
lens.org 参考文章(8)
Hamid G. Kia, Balanced pressure compression molding method ,(1991)
Edward J. Kleese, Sigurdur I. Arnason, In-the-mold coating apparatus and method ,(1978)
Donald J. Ray, Kenneth H. Woodrich, Method for making plastic panel and panel ,(1980)
Lam B. Sam, Yuichi Uchiyama, Molding process for forming complex shapes ,(1998)
Kohji Yamatsuta, Shigeyoshi Matsubara, Yoshinori Ohmura, Method of making multilayer molded article ,(1997)
Masanori Naritomi, Heterogenous foam injection molding method ,(1996)
Masataka Sakurada, Nobuyuki Iwazawa, Multilayer injection molding ,(1979)