Fracture analysis of acrylonitrile‐butadiene‐styrene resins
作者： N. S. Sridharan , L. J. Broutman
关键词:
摘要: The fracture properties of three grades acrylonitrile-buta-diene-styrene(ABS) were evaluated and compared. In preliminary studies, J1c (J integral) results obtained using the Begley Landes procedure for single-edge-notched tension specimens compact compared to establish validity criterion. It is shown that Rice single-specimen approximation can be applied this material, resulting in considerable simplification testing procedure. values two at or more rates geometry over a temperature range of–60° + 75°C. are analyzed terms modified Eyring model, activation energies ABS found 13.7 36.7 Kcals/mole, respectively.
sci-hub.se 参考文章(11)
J.R. Rice, G.F. Rosengren, Plane strain deformation near a crack tip in a power-law hardening material Journal of the Mechanics and Physics of Solids. ,vol. 16, pp. 1- 12 ,(1968) , 10.1016/0022-5096(68)90013-6
G. P. Marshall, L. E. Culver, J. G. Williams, Fracture phenomena in polystyrene International Journal of Fracture. ,vol. 9, pp. 295- 309 ,(1973) , 10.1007/BF00049197
M. Parvin, J. G. Williams, The effect of temperature on the fracture of rubber modified polystyrene Journal of Materials Science. ,vol. 11, pp. 2045- 2050 ,(1976) , 10.1007/PL00020330
D. J. Hayes, C. E. Turner, An application of finite element techniques to post-yield analysis of proposed standard three-point bend fracture test pieces International Journal of Fracture. ,vol. 10, pp. 17- 32 ,(1974) , 10.1007/BF00955076
R. W. Truss, G. A. Chadwick, Tensile deformation behaviour of ABS polymers Journal of Materials Science. ,vol. 11, pp. 111- 117 ,(1976) , 10.1007/BF00541081
C.B. Bucknall, R.R. Smith, Stress-whitening in high-impact polystyrenes Polymer. ,vol. 6, pp. 437- 446 ,(1965) , 10.1016/0032-3861(65)90028-5
J. R. Rice, A Path Independent Integral and the Approximate Analysis of Strain Concentration by Notches and Cracks Journal of Applied Mechanics. ,vol. 35, pp. 379- 386 ,(1968) , 10.1115/1.3601206
E. Plati, J. G. Williams, The determination of the fracture parameters for polymers in impact Polymer Engineering and Science. ,vol. 15, pp. 470- 477 ,(1975) , 10.1002/PEN.760150611
R. F. Boyer, Dependence of mechanical properties on molecular motion in polymers Polymer Engineering and Science. ,vol. 8, pp. 161- 185 ,(1968) , 10.1002/PEN.760080302
C. B. Bucknall, D. Clayton, Rubber-toughening of plastics: Part 1: Creep mechanisms in HIPS Journal of Materials Science. ,vol. 7, pp. 202- 210 ,(1972) , 10.1007/BF00554183