Dynamic failure of steel under hypervelocity impact of polycarbonate up to 9 km/s
作者： Tatsumi Moritoh , Shohei Matsuoka , Toshiyuki Ogura , Kazutaka G. Nakamura , Ken-ichi Kondo
DOI: 10.1063/1.1569979
关键词:
摘要: We performed hypervelocity impact experiments on SS400 steel with a polycarbonate projectile at velocities up to 9 km/s. Spall fracture damages were observed near a rear …
harvard.edu
scitation.org
aip.org
sci-hub.se 参考文章(31)
L. M. Barker, R. E. Hollenbach, Shock wave study of the α ⇄ ε phase transition in iron Journal of Applied Physics. ,vol. 45, pp. 4872- 4887 ,(1974) , 10.1063/1.1663148
Ken‐ichi Kondo, Akira Sawaoka, Shinroku Saito, Magnetoflyer method for measuring gas‐gun projectile velocities Review of Scientific Instruments. ,vol. 48, pp. 1581- 1582 ,(1977) , 10.1063/1.1134948
L.C. Chhabildas, J.E. Dunn, W.D. Reinhart, J.M. Miller, An impact technique to accelerate flier plates to velocities over 12 km/s International Journal of Impact Engineering. ,vol. 14, pp. 121- 132 ,(1993) , 10.1016/0734-743X(93)90014-X
M.D. Furnish, M.B. Boslough, G.T. Gray, J.L. Remo, Dynamical properties measurements for asteroid, comet and meteorite material applicable to impact modeling and mitigation calculations International Journal of Impact Engineering. ,vol. 17, pp. 341- 352 ,(1995) , 10.1016/0734-743X(95)99860-T
Kevin R. Housen, Robert M. Schmidt, Hole size from impacts at simulated velocities to 23 km/s International Journal of Impact Engineering. ,vol. 20, pp. 399- 410 ,(1997) , 10.1016/S0734-743X(97)87510-0
Kevin L. Poormon, Andrew J. Piekutowski, Comparisons of cadmium and aluminum debris clouds International Journal of Impact Engineering. ,vol. 17, pp. 639- 648 ,(1995) , 10.1016/0734-743X(95)99887-W
J. Osher, R. Gathers, H. Chau, R. Lee, G. Pomykal, R. Weingart, Hypervelocity acceleration and impact experiments with the LLNL electric guns International Journal of Impact Engineering. ,vol. 10, pp. 439- 452 ,(1990) , 10.1016/0734-743X(90)90078-A
R. Lee, J. Osher, H. Chau, M. Gerassimenko, G. Pomykal, R. Speer, The impact of flat, thin plates on aluminum targets in the 5–10 km/s velocity range International Journal of Impact Engineering. ,vol. 14, pp. 451- 465 ,(1993) , 10.1016/0734-743X(93)90042-6
D.E. Grady, The spall strength of condensed matter Journal of the Mechanics and Physics of Solids. ,vol. 36, pp. 353- 384 ,(1988) , 10.1016/0022-5096(88)90015-4
Woei-Shyan Lee, Chi-Feng Lin, Impact properties and microstructure evolution of 304L stainless steel Materials Science and Engineering A-structural Materials Properties Microstructure and Processing. ,vol. 308, pp. 124- 135 ,(2001) , 10.1016/S0921-5093(00)02024-4