Micro-Electric Discharge Machining in Standard Setup
作者： Satyajit Chatterjee , Santanu Das
DOI: 10.1007/978-1-84628-988-0_17
关键词:
摘要: Micro-Electric Discharge Machining is an alternative method to fabricate microstructures due its distinct advantages. However, tools for electric discharge machining (EDM) of lower diameters face problems related manufacturing low strength, difficulty in maintaining alignment and positioning accuracy. The cost the required setup accessories undergo a Micro-EDMing process make this technique popular industries.
springer.com
sci-hub.st 参考文章(7)
B.H. Yan, F.Y. Huang, H.M. Chow, J.Y. Tsai, Micro-hole machining of carbide by electric discharge machining Journal of Materials Processing Technology. ,vol. 87, pp. 139- 145 ,(1999) , 10.1016/S0924-0136(98)00345-8
Paulo Carlos Kaminski, Marcelo Neublum Capuano, Micro hole machining by conventional penetration electrical discharge machine International Journal of Machine Tools & Manufacture. ,vol. 43, pp. 1143- 1149 ,(2003) , 10.1016/S0890-6955(03)00124-X
Scott F. Miller, Albert J. Shih, Jun Qu, Investigation of the spark cycle on material removal rate in wire electrical discharge machining of advanced materials International Journal of Machine Tools & Manufacture. ,vol. 44, pp. 391- 400 ,(2004) , 10.1016/J.IJMACHTOOLS.2003.10.005
D.T Pham, S.S Dimov, S Bigot, A Ivanov, K Popov, Micro-EDM—recent developments and research issues Journal of Materials Processing Technology. ,vol. 149, pp. 50- 57 ,(2004) , 10.1016/J.JMATPROTEC.2004.02.008
T. Higuchi, K. Furutani, Y. Yamagata, K. Takeda, H. Makino, Development of Pocket-size Electro-Discharge Machine CIRP Annals. ,vol. 40, pp. 203- 206 ,(1991) , 10.1016/S0007-8506(07)61968-4
K.H Ho, S.T Newman, State of the art electrical discharge machining (EDM) International Journal of Machine Tools & Manufacture. ,vol. 43, pp. 1287- 1300 ,(2003) , 10.1016/S0890-6955(03)00162-7
P. Bleys, J.-P. Kruth, B. Lauwers, A. Zryd, R. Delpretti, C. Tricarico, Real-time Tool Wear Compensation in Milling EDM CIRP Annals. ,vol. 51, pp. 157- 160 ,(2002) , 10.1016/S0007-8506(07)61489-9