Kinetics of the axisymmetric rigid-plastic membrane subject to initial impact
作者： H. Lippmann
DOI: 10.1016/0020-7403(74)90046-0
关键词:
摘要: Abstract Starting from Tresca's yield condition and the associated flow rule, at least for not-too-extensive deformations it becomes possible to reduce rigorously title problem one single second-order partial differential equation which might be solved numerically in a straightforward manner. Instead, an approximate analytical solution is derived tentatively compared with experimental results explosive sheet metal forming though conditions are somewhat different.
elsevier.com
sci-hub.se 参考文章(8)
W. Johnson, A. Poynton, H. Singh, F.W. Travis, Experiments in the underwater explosive stretch forming of clamped circular blanks International Journal of Mechanical Sciences. ,vol. 8, pp. 237- 270 ,(1966) , 10.1016/0020-7403(66)90027-0
R. Hill, C. A theory of the plastic bulging of a metal diaphragm by lateral pressure Philosophical Magazine Series 1. ,vol. 41, pp. 1133- 1142 ,(1950) , 10.1080/14786445008561154
J. Chakrabarty, A theory of stretch forming over hemispherical punch heads International Journal of Mechanical Sciences. ,vol. 12, pp. 315- 325 ,(1970) , 10.1016/0020-7403(70)90085-8
Horst Lippmann, Ebenes Hochkantbiegen eines schmalen Balkens unter Berücksichtigung der Verfestigung Ingenieur-Archiv. ,vol. 27, pp. 153- 168 ,(1959) , 10.1007/BF00536385
W. Johnson, K. Kormi, F.W. Travis, An investigation into the explosive deep drawing of circular blanks using the plug-cushion technique International Journal of Mechanical Sciences. ,vol. 6, pp. 287- 294 ,(1964) , 10.1016/0020-7403(64)90033-5
Manohar Singh, A linearized theory of tube drawing Zeitschrift für Angewandte Mathematik und Physik. ,vol. 15, pp. 1- 21 ,(1964) , 10.1007/BF01679522
B. Kaftanoglu, J.M. Alexander, On quasistatic axisymmetrical stretch forming International Journal of Mechanical Sciences. ,vol. 12, pp. 1065- 1084 ,(1970) , 10.1016/0020-7403(70)90033-0
D.M. Woo, The analysis of axisymmetric forming of sheet metal and the hydrostatic bulging process International Journal of Mechanical Sciences. ,vol. 6, pp. 303- 317 ,(1964) , 10.1016/0020-7403(64)90034-7