Influence of process parameters on surface roughness of aluminum parts produced by DMLS.
作者： F. Calignano , D. Manfredi , E. P. Ambrosio , L. Iuliano , P. Fino
DOI: 10.1007/S00170-012-4688-9
关键词:
摘要: Direct metal laser sintering (DMLS) is an additive manufacturing technique for the fabrication of near net-shaped parts directly from computer-aided design data by melting together different layers with help a source. This paper presents investigation surface roughness aluminum samples produced DMLS. A model based on L18 orthogonal array Taguchi was created to perform experimental planning. Some input parameters, namely power, scan speed, and hatching distance were selected investigation. The upper surfaces analyzed before after shot peening. morphology means field emission scanning electron microscope. Scan speed found have greatest influence roughness. Further, peening can effectively reduce
springer.com
unirioja.es
sci-hub.se 参考文章(30)
Genichi Taguchi, Introduction to quality engineering.... apo. ,(2014)
K. F. Leong, C. S. Lim, C. K. Chua, Rapid Prototyping: Principles And Applications ,(2010)
K.W.Dalgarno, Jae-Kyoo Lim, Montasser M.Dewidar, A Comparison between Direct and Indirect Laser Sintering of Metals Journal of Materials Science & Technology. ,vol. 24, pp. 227- 232 ,(2009)
Y.P. Kathuria, Microstructuring by selective laser sintering of metallic powder Surface & Coatings Technology. ,vol. 116, pp. 643- 647 ,(1999) , 10.1016/S0257-8972(99)00266-2
Ian Gibson, Dongping Shi, Material properties and fabrication parameters in selective laser sintering process Rapid Prototyping Journal. ,vol. 3, pp. 129- 136 ,(1997) , 10.1108/13552549710191836
Jordi Delgado, Joaquim Ciurana, Ciro A. Rodríguez, Influence of process parameters on part quality and mechanical properties for DMLS and SLM with iron-based materials The International Journal of Advanced Manufacturing Technology. ,vol. 60, pp. 601- 610 ,(2012) , 10.1007/S00170-011-3643-5
H.H. Zhu, L. Lu, J.Y.H. Fuh, Development and characterisation of direct laser sintering Cu-based metal powder Journal of Materials Processing Technology. ,vol. 140, pp. 314- 317 ,(2003) , 10.1016/S0924-0136(03)00755-6
Yong-Ak Song, Wilfried Koenig, Experimental Study of the Basic Process Mechanism for Direct Selective Laser Sintering of Low-Melting Metallic Powder CIRP Annals. ,vol. 46, pp. 127- 130 ,(1997) , 10.1016/S0007-8506(07)60790-2
Hong-Seok Byun, Kwan H. Lee, Determination of the optimal build direction for different rapid prototyping processes using multi-criterion decision making Robotics and Computer-integrated Manufacturing. ,vol. 22, pp. 69- 80 ,(2006) , 10.1016/J.RCIM.2005.03.001