Tribological Properties of Self-Lubricating Polymer–Steel Laminated Composites
作者： Dong-Ya Zhang , Peng-Bo Zhang , Ping Lin , Guang-Neng Dong , Qun-Feng Zeng
DOI: 10.1080/10402004.2013.805348
关键词:
摘要: Self-lubricating polymer–steel laminated composites (SLC) consisting of matrix zones and filled were fabricated by a laminating–bonding process. The silicon steel sheets the polymer with MoS2 graphite, respectively. control specimen was prepared spraying composite coating on GCr15 disc. tribological properties SLC investigated using ball-on-disc tribometer under different loads frequencies. Compared to specimen, friction coefficient wear rate reduced 57% threefold at 4 N 6 Hz, In addition, low stable reciprocating frequency, it high fluctuating frequency. increased increasing applied load Scanning electron microscopy (SEM) images show that lubricating mechanism solid lubricants embedded...
sci-hub.se 参考文章(30)
A. D. Sarkar, Friction and wear ,(1980)
M. Hadad, G. Blugan, J. Kübler, E. Rosset, L. Rohr, J. Michler, Tribological behaviour of Si3N4 and Si3N4–%TiN based composites and multi-layer laminates Wear. ,vol. 260, pp. 634- 641 ,(2006) , 10.1016/J.WEAR.2005.03.027
Dongya Zhang, Ping Lin, Guangneng Dong, Qunfeng Zeng, Mechanical and tribological properties of self-lubricating laminated composites with flexible design Materials & Design. ,vol. 50, pp. 830- 838 ,(2013) , 10.1016/J.MATDES.2013.03.068
Du-Xin Li, Yi-Lan You, Xin Deng, Wen-Juan Li, Ying Xie, Tribological properties of solid lubricants filled glass fiber reinforced polyamide 6 composites Materials & Design. ,vol. 46, pp. 809- 815 ,(2013) , 10.1016/J.MATDES.2012.11.011
Ya-e Qi, Yong-Sheng Zhang, Li-Tian Hu, High-temperature self-lubricated properties of Al2O3/Mo laminated composites Wear. ,vol. 280, pp. 1- 4 ,(2012) , 10.1016/J.WEAR.2012.01.010
H. Meng, G.X. Sui, G.Y. Xie, R. Yang, Friction and wear behavior of carbon nanotubes reinforced polyamide 6 composites under dry sliding and water lubricated condition Composites Science and Technology. ,vol. 69, pp. 606- 611 ,(2009) , 10.1016/J.COMPSCITECH.2008.12.004
Xian Jia, Xiaomei Ling, Donghai Tang, Microstructures and friction-wear characteristics of bivalve shells Tribology International. ,vol. 39, pp. 657- 662 ,(2006) , 10.1016/J.TRIBOINT.2005.05.001
Liwen Mu, Yijun Shi, Xin Feng, Jiahua Zhu, Xiaohua Lu, The effect of thermal conductivity and friction coefficient on the contact temperature of polyimide composites: Experimental and finite element simulation Tribology International. ,vol. 53, pp. 45- 52 ,(2012) , 10.1016/J.TRIBOINT.2012.04.003
N. Laraqi, N. Alilat, J.M. Garcia de Maria, A. Baïri, Temperature and division of heat in a pin-on-disc frictional device—Exact analytical solution Wear. ,vol. 266, pp. 765- 770 ,(2009) , 10.1016/J.WEAR.2008.08.016
S. Bueno, L. Micele, C. Melandri, C. Baudin, G. De Portu, Improved wear behaviour of alumina–aluminium titanate laminates with low residual stresses and large grained interfaces Journal of The European Ceramic Society. ,vol. 31, pp. 475- 483 ,(2011) , 10.1016/J.JEURCERAMSOC.2010.11.002