Zirconia: cementation of prosthetic restorations. Literature review.

作者: Marco Gargari , Alberto Maria Pujia , E. Napoli , F. Gloria

DOI:

关键词:

摘要: Aim of the work. work was to execute a review international literature about cementation zirconia restorations, analyzing properties cements most commonly used in clinical activities. Materials and methods. It performed, through PubMed, bibliographic search on last 10 years using following limits: studies English, vitro studies, randomized trial, reviews, meta-analysis, guide-lines. Were excluded from search: descriptive case reports, discussion articles, opinion’s leader. Results. From results that common surface treatments (silanization, acid etching) are ineffective because it has an inert without glassy component (on which this act primarily), instead sandblasting at 1atm with aluminium oxide ( Al2O3) significantly effective for resulting roughening increase energy wettability material. Furthermore been shown zinc phosphate-based cements, Bis-GMA-based glass-ionomer can’t guarantee stable long-term adhesion, resin containing phosphate monomer 10-methacryloyloxyidecyl-dihyidrogenpho­sphate (MDP) have higher adhesion stability values than other cements. In particular, seen bond strength copings dentin, MDP-based cement, is 6,9MPa; value comparable obtained gold cementation. Conclusions. Analyzed led conclusions: best treatment improve between zirconia; ester monomers 10-methacryloyloxyidecyl-dihyidrogenphosphate after ageing treatment; procedure cementing restorations combination (Al2O3) 50µm

参考文章(18)
T Dérand, P Dérand, Bond strength of luting cements to zirconium oxide ceramics. International Journal of Prosthodontics. ,vol. 13, pp. 131- 135 ,(2000)
Andree Piwowarczyk, Hans-Christoph Lauer, John A Sorensen, The shear bond strength between luting cements and zirconia ceramics after two pre-treatments. Operative Dentistry. ,vol. 30, pp. 382- 388 ,(2005)
Massimiliano Guazzato, Kaarel Proos, Linda Quach, Michael Vincent Swain, Strength, reliability and mode of fracture of bilayered porcelain/zirconia (Y-TZP) dental ceramics. Biomaterials. ,vol. 25, pp. 5045- 5052 ,(2004) , 10.1016/J.BIOMATERIALS.2004.02.036
Rosario P. Palacios, Glen H. Johnson, Keith M. Phillips, Ariel J. Raigrodski, Retention of zirconium oxide ceramic crowns with three types of cement Journal of Prosthetic Dentistry. ,vol. 96, pp. 104- 114 ,(2006) , 10.1016/J.PROSDENT.2006.06.001
Jukka P. Matinlinna, Lippo V. J. Lassila, Pekka K. Vallittu, Pilot evaluation of resin composite cement adhesion to zirconia using a novel silane system. Acta Odontologica Scandinavica. ,vol. 65, pp. 44- 51 ,(2007) , 10.1080/00016350600973060
Claus-Peter Ernst, Udo Cohnen, Elmar Stender, Brita Willershausen, In vitro retentive strength of zirconium oxide ceramic crowns using different luting agents. Journal of Prosthetic Dentistry. ,vol. 93, pp. 551- 558 ,(2005) , 10.1016/J.PROSDENT.2005.04.011
T. Kosmač, C. Oblak, P. Jevnikar, N. Funduk, L. Marion, The effect of surface grinding and sandblasting on flexural strength and reliability of Y-TZP zirconia ceramic. Dental Materials. ,vol. 15, pp. 426- 433 ,(1999) , 10.1016/S0109-5641(99)00070-6
Glen H. Johnson, Xavier Lepe, David J. Bales, Crown retention with use of a 5% glutaraldehyde sealer on prepared dentin Journal of Prosthetic Dentistry. ,vol. 79, pp. 671- 676 ,(1998) , 10.1016/S0022-3913(98)70074-5
Ivan Balducci, Luiz Felipe Valandro, Luiz Felipe Valandro, Marco Antonio Bottino, Regina Amaral, Mutlu Ozcan, Effect of conditioning methods on the microtensile bond strength of phosphate monomer-based cement on zirconia ceramic in dry and aged conditions. Journal of Biomedical Materials Research Part B. ,vol. 85, pp. 1- 9 ,(2008) , 10.1002/JBIM.B.30908
H LUTHY, O LOEFFEL, C HAMMERLE, Effect of thermocycling on bond strength of luting cements to zirconia ceramic Dental Materials. ,vol. 22, pp. 195- 200 ,(2006) , 10.1016/J.DENTAL.2005.04.016