Fixture for use in preparing twisted pair cables for attachment to an electrical connector

作者: Kevin Hudson Snead , Jess Britt Ferrill

DOI:

关键词:

摘要: An apparatus and method for preparing the end of a cable which may be used in fabrication Category 5 patch cord assembly. The includes clamp subassembly bonding members located between wire combs that position wires side by side. are bonded heating elements members. These comprise mounted on printed circuit board. board heater can replaced so with different insulation and/or sizes prepared tool. Exposed pairs untwisted laced combs. A prevents portion remaining jacket from untwisting. insert is placed two other six to improve near crosstalk performance. upper then rotated into place ends bonded. shifted, moving wires, cut length. proper preselected order insertion an RJ-45 modular plug, example, fabricate assembly meeting requirements.

参考文章(16)
Daniel R. Coldren, Jon A. Fortuna, Wayne S. Davis, Electrical connector and wire assembly method ,(1985)
Irvin R. Triner, Craig A. Bixler, Electrical connector and method of assembly ,(1987)
Douglas Lindstrand, Lester T. Turner, Grigory Men, Albert R. Cox, Robert J. Biegon, Mass terminable flat cable and cable assembly incorporating the cable ,(1987)
Terrence Meighen, Walter M. Phillipson, Robert J. Brennan, Jack and connector ,(1985)
Claude Rolland, Jacques Delalle, Wire inserting and trimming apparatus ,(1975)
O Yazaki Parts Co. Ltd. Nakayama, O Yazaki Parts Co. Ltd. Harada, O Yazaki Parts Co. Ltd. Suzuki, O Yazaki Parts Co. Ltd. Aiso, Mineo C, Toshihiko C, O Yazaki Parts Co. Ltd. Takahashi, O Yazaki Parts Co. Ltd. Yamashima, Satoshi C, Keiji C, Susumu C, Osamu C, Method and apparatus for making a flat wiring harness ,(1989)