Effect of hot isostatic pressing on cast A357 aluminium alloy with and without SiC particle reinforcement
作者： A. Zulfia , H. V. Atkinson , H. Jones , S. King
关键词:
摘要: The effect of Hot Isostatic Pressing (HIPping) treatments on porosity in the aluminium casting alloy A357 and stir-cast A357/15 vol % SiC particulate Metal Matrix Composite has been investigated. Densitometry image analysis have used to determine apparent percentage porosity. Four HIPping temperature profiles investigated (103 MPa pressure) mechanical testing carried out by single notch four point bending. bend strength was increased after relative as-received. optimum cycle involved for a short time semi-solid region followed sustain below solidus.
springer.com
sci-hub.se 参考文章(5)
T. W. Clyne, P. J. Withers, An introduction to metal matrix composites ,(1993)
B. A. Rickinson, S. Andrews, Hot Isostatic Processing ,(1991)
Hans T. Larker, Richard Larker, Hot Isostatic Pressing Materials Science and Technology. ,(2006) , 10.1002/9783527603978.MST0201
E. Pagounis, M. Talvitie, V.K. Lindroos, Consolidation behavior of a particle reinforced metal matrix composite during HIPing Materials Research Bulletin. ,vol. 31, pp. 1277- 1285 ,(1996) , 10.1016/0025-5408(96)00111-0
K. Hanada, M.J. Tan, Y. Murakoshi, H. Negishi, T. Sano, Influence of HIP parameters on mechanical properties of AA8090 Journal of Materials Processing Technology. ,vol. 48, pp. 399- 405 ,(1995) , 10.1016/0924-0136(94)01675-Q