A review of the theory of rolling contact stresses
作者： K.L. Johnson
DOI: 10.1016/0043-1648(66)90010-X
关键词:
摘要: Abstract Recent developments in the theory of rolling contact stresses are reviewed. They follow three main lines: 1. (1) elastic due to slip and friction at interface, 2. (2) pressures developed elasto-hydrodynamic lubricating films 3. (3) influence inelastic (visco-elastic or plastic) behaviour material solids. The dry solids is now an advanced state development. Studies lubricated deformation restricted two-dimensional problems cylinders. It has been possible however put forward a tentative theoretical load-carrying capacity for metal rollers, above which continuous permanent will take place. suggested that strength actual surfaces falls below limit non-homogeneity roughness surfaces. These effects present beyond scope but would well repay study.
elsevier.com
sci-hub.se 参考文章(23)
Walter Wernitz, Wälz-Bohrreibung : Bestimmung der Bohrmomente und Umfangskräfte bei Hertz'scher Pressung mit Punktberührung F. Vieweg. ,(1958)
The Lubrication of Rollers IV. Measurements of Friction and Effective Viscosity Philosophical Transactions of the Royal Society A. ,vol. 255, pp. 281- 312 ,(1963) , 10.1098/RSTA.1963.0005
, G. M. Hamilton, Plastic Flow in Rollers Loaded above the Yield Point Proceedings of the Institution of Mechanical Engineers. ,vol. 177, pp. 667- 675 ,(1963) , 10.1243/PIME_PROC_1963_177_051_02
W. D. May, E. L. Morris, D. Atack, Rolling Friction of a Hard Cylinder over a Viscoelastic Material Journal of Applied Physics. ,vol. 30, pp. 1713- 1724 ,(1959) , 10.1063/1.1735042
Frederick William Carter, On the action of a locomotive driving wheel Proceedings of The Royal Society A: Mathematical, Physical and Engineering Sciences. ,vol. 112, pp. 151- 157 ,(1926) , 10.1098/RSPA.1926.0100
, J. E. Merwin, K. L. Johnson, An Analysis of Plastic Deformation in Rolling Contact Proceedings of the Institution of Mechanical Engineers. ,vol. 177, pp. 676- 690 ,(1963) , 10.1243/PIME_PROC_1963_177_052_02
P. H. Dawson, Effect of Metallic Contact on the Pitting of Lubricated Rolling Surfaces Archive: Journal of Mechanical Engineering Science 1959-1982 (vols 1-23). ,vol. 4, pp. 16- 21 ,(1962) , 10.1243/JMES_JOUR_1962_004_005_02
D. Dowson, A. V. Whitaker, The Isothermal Lubrication of Cylinders Tribology Transactions. ,vol. 8, pp. 224- 234 ,(1965) , 10.1080/05698196508972097
Lubrication at Point Contacts Proceedings of The Royal Society A: Mathematical, Physical and Engineering Sciences. ,vol. 261, pp. 532- 550 ,(1961) , 10.1098/RSPA.1961.0094
The Lubrication of Rollers II. Film Thickness with Relation to Viscosity and Speed Philosophical Transactions of the Royal Society A. ,vol. 254, pp. 223- 236 ,(1961) , 10.1098/RSTA.1961.0015