The influence of mineral additives on the strength and porosity of OPC mortar

作者: S.P Pandey , R.L Sharma

DOI: 10.1016/S0008-8846(99)00180-5

关键词:

摘要: Abstract Mercury intrusion porosimetry study was carried out on samples of ordinary Portland cement mortars made with mineral additives such as fly ash, granulated blast furnace slag, phosphorous limestone, and lime sludge. The total porosity compressive strength all the blended mortar were determined at 7, 28, 90 days hydration. mean pore diameter found to increase addition ash slags, although volume almost same. decrease in porosity, but extent more closely related slags than limestone Acceleration development also observed sludge addition.

参考文章(8)
Other Mineral By-Products in Concrete, V. M. Malhotra, Fly ash, silica fume, slag & other mineral by-products in concrete American Concrete Institute. ,(1983)
PA Wedding, D Manmohan, PK Mehta, Influence of Pozzolanic, Slag, and Chemical Admixtures on Pore Size Distribution and Permeability of Hardened Cement Pastes Cement Concrete and Aggregates. ,vol. 3, pp. 63- 67 ,(1981) , 10.1520/CCA10203J
Seishi Goto, Della M. Roy, The effect of w/c ratio and curing temperature on the permeability of hardened cement paste Cement and Concrete Research. ,vol. 11, pp. 575- 579 ,(1981) , 10.1016/0008-8846(81)90087-9
R.F. Feldman, Significance of Porosity Measurements on Blended Cement Performance Special Publication. ,vol. 79, pp. 415- 434 ,(1983) , 10.14359/6705
P.K. Mehta, Studies on blended Portland cements containing Santorin earth Cement and Concrete Research. ,vol. 11, pp. 507- 518 ,(1981) , 10.1016/0008-8846(81)90080-6