Method of fabricating crystal unit, crystal unit fabrication mask, and crystal unit package
作者： Hajime Kubota , Masakazu Kishi , Masayuki Itoh
DOI:
关键词: Materials science 、 Fabrication 、 Blank 、 Unit (ring theory) 、 Composite material 、 Engineering drawing 、 Penetration (firestop) 、 Base (geometry) 、 Crystal 、 Heating element 、 Adhesive
摘要: A method of fabricating a crystal unit fills an adhesive from first opening in front surface mask each penetration holes the state which is set on base, into hole, and heats, by heating element, sidewall region defining second back mask, order to cure part hole contact with filling hole. blank bonded base using form unit, after removing base.
lens.org 参考文章(10)
Shin Woong Bang, Jong Tae Kim, Se Young Seo, Hee Young Jun, Jong Pil Lee, Ceramic package for crystal oscillator ,(2003)
Jacob M. Li, Roger L. Clark, Joseph V. Adler, Evacuated hybrid ovenized oscillator ,(2001)
Kenji Kobae, Norio Kainuma, Shunji Baba, Takatoyo Yamakami, Hiroshi Kobayashi, Hidehiko Kira, Method of mounting semiconductor chip ,(2002)
Izumi Yamamoto, Package base for mounting electronic element, electronic device and method of producing the same ,(2002)
Steven J. Fry, Low profile ovenized oscillator packing having a high thermal conductivity substrate ,(1998)
Jean-Marc Navet, Oscillator device comprising a thermally-controlled piezoelectric resonator ,(2009)
Steve Stoffels, Hendrikus Tilmans, Temperature Compensation Device and Method for MEMS Resonator ,(2011)
Guan Xiufen, Wang Lifei, Sun Shizhang, Method of screening chromatographic stuffing from pearlite ,(2003)